Richmat HJH82B Ble Smart Home Remote Control User Manual
- June 9, 2024
- Richmat
Table of Contents
Richmat HJH82B Ble Smart Home Remote Control
Remote control button map
System configuration diagram
Remote control function description
Button
label
|
Features
---|---
1
| Short press and release to run to ZG position (with initial value). Multiplexing function: FLA+ZG, the backlight flashes, the buzzer sounds, and the current motor position is recorded to the ZG position. (Power-off clear).
2
| Short press and release to run to the M position (no initial value). Multiplexing function: FLAT+M, the backlight flashes, the buzzer sounds, and
the current motor position is recorded to the M position. (Power off does not clear).
3
|
Back up, release to stop
4| Feet rise, release to stop
5
|
One key reset, all motors reset to the end
6
|
Back down, release to stop
7
|
Feet down, release to stop
8| Back and feet rise at the same time, release to stop
9
|
Back and feet descend at the same time, release to stop
Coding m et h o d :
1. The back of the remote control is raised + the foot is raised (3, 4) + the
buzzer of the control box pairing key will sound, indicating that the pairing
is successful.
Precautions:
To protect the reliability and safety of the motor and control box, do not
switch the buttons frequently.
FCC
Caution:
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions:
- this device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>