Richmat Smart Home HJH129 Ble Instruction Manual
- June 3, 2024
- Richmat
Table of Contents
Richmat Smart Home HJH129 Ble
Remote control button silicone diagram
Remote control function description
Button label | Function |
---|
1
| Press the button, the motor runs to the memory position ZG with one button
Multiplexing function: long press FLAT+ZG for about 3s, the buzzer will sound, and the current motor
position will be recorded to ZG.
2
| Press the button, the motor will run to the memory position M1 with one button
Multiplexing function: long press FLAT+ M1 for about 3s, the buzzer will sound, and the current motor
position will be recorded to M1.
3| The head motor extends.
4| The foot motor extends.
5| One key reset, all motors retract to the minimum
stroke position.
6| Head motor retracts.
7| Foot motor retracts.
8| MODE (C/P/W three mode switching)
9| TIMER/ALL OFF (10,20,30 switch, default 30 minutes)
10
| The head massager is enhanced, the massager can be turned on (automatically turn off after 30 minutes)
(1→2→3→Off cycle switching)
11
| The foot massager is enhanced, the massager can be
turned on (automatically turn off after 30 minutes) (1→2→3→Off cycle switching)
Coding m et h o d :
[Remote head up + foot up (3,4) + control box pairing key] The buzzer sounds,
indicating that the pairing is successful.
Precautions
To protect the reliability and safety of the motor and control box, do not switch the buttons frequently.
FCC
Caution:
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>