Richmat Smart home HJH13D Ble Instruction Manual
- June 3, 2024
- Richmat
Table of Contents
Product function manual
Smart home
HJH13D Ble
Smart home HJH13D Ble
一、 Remote control button silicone diagram
二、 Remote control function description
| Button label | Function |
|---|---|
| 1 | The head motor extends. |
| 2 | The head motor retracts. |
| 3 | The foot motor extends. |
| 4 | The foot motor retracts. |
| 5 | The motor runs to the M position with one button (with initial value). |
Multiplexing function: long press ZG for about 3s, the backlight flashes, the
buzzer sounds, and the current motor position is recorded to ZG. (Clear after
power failure)
6| Tap to turn on/off the bed light, long press to turn on the flashlight,
release the flashlight to turn off.
7| One-key reset, all motors retract to the minimum stroke position and reset
after power-on.
Coding method: [Remote control head up + foot up (1, 2) + control box
code matching key] The buzzer sounds, indicating successful code matching.
Precautions:
To protect the reliability and safety of the motor and control box, do not
switch the buttons frequently.
Caution:
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions:
- this device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a articular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the ser is encouraged to try to correct the interference by one or more
of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>