LECTRON Tesla J1772 Charging Adapter User Manual
- June 8, 2024
- LECTRON
Table of Contents
LECTRON Tesla J1772 Charging Adapter User Manual
In the Box
1 x Tesla to J1772 Adapter
Safety Information
- When connecting to Tesla Destination Chargers, make sure that the output is less than 48A.
- When connecting the Lectron Adapter to the Tesla Charger, always wait 30s before connecting the other end to your J1772 EV.
Compatibility
- Tesla High Power Wall Connector
- Tesla Destination Charger Gen 1, 2, 3
- Tesla Mobile Connector
Introduction to Parts
- Tesla Adapter plug
- Lectron J1772 plug
Warnings
- Read this manual before using the Lectron Adapter. Failure to follow the instructions or warnings in this document can result in fire, electrical shock, serious injury.
- Do not attempt to open, disassemble, repair, tamper with, or modify the adapter.
- Do not let it get wet or near heat sources.
How to use
Step1: Connect the Tesla Charger to the Lectron Adapter. Wait at least 30s before connecting it to your J1772 electric vehicle.
Step 2: Firmly plug in the Lectron Adapter into your J1772 electric
vehicle.
Note: If you are using Tesla Destination Charger or a Tesla Wall
Connector and see a red light blinking on the charger, immediately adjust the
charger current to 48A or below (set the rotary switch to position 1-8).
FAQ
Is the Lectron Adapter waterproof?
The Lectron Adapter is IP54-rated making it weatherproof. However, it is
recommended to not let the Lectron Adapter get wet.
How fast can this fully charge my EV?
The maximum power output is 11.5kW (48A, 240V). The exact charging speed
depends on various factors: use of a portable Tesla charger, different Tesla
charging stations models, different J1772 EV car models used with different
battery sizes, etc…
Can you leave the adapter connected to the Tesla wall charger?
It is recommended to disconnect the Lectron Adapter from the Tesla Charger
after each use.
Get More Support
Scan the QR code below or email us at: contact@ev- lectron.com.
Specifications
Voltage: Max 250V AC
Current: Max 48A
Operating temperature: -22˚F to +122˚F
Charging port: SAE J1772 Standard
Connector port: Tesla US
Weight: 1.12 lbs
Tesla Charger is not included. Lectron is not affiliated with Tesla Inc. Lectron is a trademark of Dropcases Ltd. Tesla Charger is a trademark of Tesla Inc.
For more information, visit:
www.ev-lectron.com
or contact us at
contact@ev-lectron.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>