LECTRON SC-PPC030 EV Portable Charger User Guide
- June 9, 2024
- LECTRON
Table of Contents
LECTRON SC-PPC030 EV Portable Charger
INSTRUCTION FOR USE
INITIATE
FINISH
LED DISPLAY STATUS
NOTE
Please set the charging current before inserting the plug into the vehicle.
Otherwise, it will startcharging immediately and you cannot set the parameters
after that.
ILLUSTRATION OF SCREEN
- Real-time voltage
- Charging time
- S.Real-time current
- Rated current
- Charge amount
- Unit Temperature
- Charging icon
- Cause of fault
GOOD TO KNOWN
- This is a Mode 2/Level 2 EV charging cable only for EVs with Type 1/ Type 2 inlets. Don’t use it for EVs with other types of inlets.
- This cable has complicated internal structure. Please do not take it apart without any protessional technical support.
- Don’t use it in the water.
- This product is only for EV charging. Please don’t use it for any other purposes.
PROFESSIONAL SPECIFICATION
KEY FEATURES
IP66:
It can be used in most outdoor environments. The IP66-rated enclosure gives
protection against low-pressure water jets from any direction, as well as
condensation and water spray.
High Compatibility:
Compatible to all EVs with Type 1/Type2 inlets.
Safety Assurance:
Already passed all tests of CE. All kinds of protective measures are taken to
ensure the safety of every user.
Current adjustable:
Currently, the product has 2 to 5 charging current switching modes. Please
refer to the actual switch version you purchased.
Rugged Enclosure:
To present top notch quality, we use brand-new design and solidly build high
strength ABS plastic. The charger is proved to be able to bear the weight of a
car.
Intelligent Chip:
Automatically repair minor charge ways to indicate different problems to help
you distinguish the charging situation. problems while charging. The light
will blink in different
SECURITY PROTECTION
ABOUT MAINTENANCE
In order to ensure the normal service life of the charger and reduce the risk, maintenance must be performed regularly. The maintenance of the equipment needs to be completed by profes- sionals, with use of qualified and safe maintenance tools. Please avoid strong bumping during transportation in order to protect the outer package of the product. The product should be placed at an ambient temperature of-25 C+55°C with a relative humidi ty of less than 95%. The ambient air should not contain acids, alkalis or other corrosive gases and explosive gases, It also should be away from rain, snow, wind and sand.
OVERHAUL
Mode 2/Level 2 Charging Cable is subject to stringent quality inspections. We offer one year warranty for any quality problems from the day of purchase. Please contact our service depart ment tor after-sale issues. The warranty above does not cover any defect caused by negligence, abuse, misuse, accident, modiication, tampering, alteration,taulty installation.
FAILURE DESCRIPTION
Leakage Protection
- Check whether there are any foreign objects or water in the charging plug or vehicle socket.
- Unplug and reconnect. If the fault persists, please check the entirecharging circuit before trying again. if the problem remains after multiple attempts, please stop using the charger and contact the after-sales personnel.
Over Current
- Check the selected power. Try again with higher current and restart.
- If the above operation does not work try to charge your vehicle with another AC charger. If your vehicle works well, please stop using the charger and contact the after-sales personnel
Short Circuit
- Check the selected power. Try again with higher current and restart.
- if the above operation does not work, try to charge your vehicle with another AC charger. If your vehicle works well, please stop using the charger and contact the after-sales personnel.
Over Temperature
- The current ambient temperature is too high, so the charger stops to keep you safe.
- Charging will restart automatically when the temperature returns to an appropriate range.
Over Voltage
- Measure the input voltage to see if the current voltage is too high.
- Try to charge at another time.
- Voltage stabilizer is recommended to use for safety if the voltage in your area is often unstable.
CP Error
A communication error between the vehicle and charger has occurred.
- Unplug and reconnect. Make sure the plug is completely inserted.
- If the above operation does not work try to charge your vehicle with another AC charger. If your vehicle works well, please stop using the charger and contact the after-sales personnel.
SECURITY WARNING
ATTENTION
Non-compliance with the operating instructions can cause serious consequences.
Manutacturer does not assume any liability for damage caused by disregarding
operating instructions or other warnings marked on the device. High voltage.
fire hazardi Never use the device if the housing is damaged or opened! This
product is not suitable tor people with limited mobility, sensory or
psychological disabilities, and those who lack use experience or a certain
degree of knowledge.
An IMPORTANT SAFETY INSTRUCTIONs WARNING!
- A regular check if the charger has visible damage. Do not use a damaged product.
- Make sure that all safety facilities and connections are available, properly installed and undamaged at all times and are tested regularly to ensure they can operate normally.
- Make sure that the input voltage, frequency, circuit breakers and other conditions of the device meet the specifications betore the device is powered on. Iit’s important to observe the maximum permissible charging current of the connection.
- To ensure the service life and stable operation of the charger, the operating environment should be kept as clean as possible with a relatively stable temperature and humidity. The charger must not be used in a flammable environments or environments with volatile gas.
- Please keep the power cord away from the heated surface. Please do not put the power cord in the gap of the closed door or pull it out of sharp edges or corners.
- Do not use the charger when the inside of the charging plug is wet.
- Do not modify, retrofit, or change any part by yourself under any circumstances.
- Please do not use this product as a toy. Please take good care of children to ensure that they will not play with this device as a toy nor put their fingers into the charging connector when the power plug is still connected.
- The circuit to which the charger is to be connected must be equipped with a residual current circuit breaker.
NOTE
- Please do not use it for other purposes except clectric car charging.
- Do not try to disassemble the device by yourself under any circumstances. otherwise, the internal precision parts may be damaged, and you will not be able to apply after-sales service.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>