DIAMONDBACK Cross Bin 13 Truck Covers Installation Guide
- June 3, 2024
- DIAMONDBACK
Table of Contents
DIAMONDBACK Cross Bin 13 Truck Covers
PARTS INCLUDED
PRE-INSTALLATION NOTE
Install your DiamondBack cover before installing the Cross Bin. If you have a ’19–up Ram 1500 with Multifunction Tailgate, remove the factory reinforcement brackets from the front corners of the cargo bed first.
INSTRUCTIONS
-
Open the cab panel of the cover. Detach the bottom ends of its gas springs from their ball studs. Fold the panel completely back until it rests on the closed portion of the cover.
-
Place the bin into the cargo bed so that its support flanges rest on the bed rails.Many pickup truck cargo beds are tapered, which means that many Cross Bins have a front and back. Look for the word “CAB” etched into one of the longer walls of the bin (could be on inside or outside of wall); make that wall the one nearest the cab.
-
Move the bin as far forward as possible.
-
Optional: For bumpy driving conditions, fasten the bin to the bed rail lips using self-drilling sheet metal screws.
To fasten the bin to a current-generation F-Series pickup, use rivet nuts and bolts. -
If you have a ’19–up Ram 1500 with Multifunction Tailgate, reinstall the factory reinforcement brackets in the front corners of the cargo bed now.
-
If you just installed the bin under a DiamondBack cover you’ve had for a while, you may find that your cab-pan-el lock rods are now more difficult to operate. If so, use the rod guide brackets and a 7/16″ socket to lower the rods slightly.
Remember to keep the cargo in the Cross Bin clear of cab panel’s safety catch to avoid interference.
Documents / Resources
|
DIAMONDBACK Cross Bin 13 Truck
Covers
[pdf] Installation Guide
Cross Bin 13, Truck Covers, Cross Bin 13 Truck Covers, Covers
---|---
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>