LED Light Remote Control LED Studio Light Kit Instructions
- June 7, 2024
- LED Light
Table of Contents
LED Light Remote Control LED Studio Light Kit Instructions
VL-35K 35 Watt LED Studio Light Kit
Remote Control ② Instructions
-
Main ON Switch
-
Main OFF Switch
-
Brightness+
-
Brightness-
-
ON
-
OFF
-
Filter
Group matching
Step 1: While the socket is in the off position, press the (5) button for 5
seconds. Continue to press while going to Step 2..
Step 2: Switch the lamp socket to the on “ON” position. If the LED bulb
flashes, it has been successfully paired with the remote control. Remove
finger from the (5) button. The (5) button will now be the “ON” switch for
that bulb and the (6) switch will be the “OFF” switch
Step 3:: Repeat the above steps with the second LED bulb using the buttons
marked “Group 2” in the above illustration.
Step 4: The remote control can also be used to pair up to 2 extra bulbs sold
separately.
Unpairing LED bulb
To unpair,repeat the above”Group matching”steps with a paired bulb.
Operation
Step 1: Use button (5) to turn on the paired bulb.
Step 2: After the light has been selected and turned on, use button (3) to
brighten and button (4) to dim the bulb.
Step 3: After the light has been turned off using the remote control, the
bulbs fan will remain running. Turn the switch on the lamp socket to the ‘OFF”
position to turn the fan off. No cool down time is necessary.
Step 4: To remove the clear dome, screw counterclockwise until the dome
separates from the bulb. If you prefer a warmer light, add the orange dome by
screwing to the front of the bulb in a clockwise direction until snug. Add the
blue dome to add blue special effect.
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and
(2) this device must accept any interference received, including interference
that may cause undesired operation This device has been tested and found to
comply with the limits for a Class B digital device, pursuant to Part 15 of
the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This device
generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will
not occur in a particular installation. If this device does cause harmful
interference to radio or television reception, which can be determined by
turning the device off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
–Reorient or relocate the receiving antenna.
–Increase the separation between the device and receiver.
–Connect the device into an outlet on a circuit different from that to which
the receiver is connected.
–Consult the dealer or an experienced radio/TV technician for help
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment
Read More About This Manual & Download PDF:
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>