wali Single Gas Spring Arm User Guide
- June 7, 2024
- WALI
Table of Contents
wali Single Gas Spring Arm
Supplied Parts List
Step 1
Compatible with most WALI desk monitor mount with 1.375” (3.5cm) diameter
center pole.
Put the Arm through the Pole, adjust the preferred height and tighten using
Allen Key 6mm. (Pole not included)
Step 2
Step 2.1 Select TV Screws
Only one screw size fits your TV
Hand thread screws into the threaded inserts on the back of your TV to
determine which screw diameter (M4 or M5) to use.
Step 2.2 Select Spacers ( if needed )
NOT NEEDED
NEEDED FOR
Step 2.3a
Select M4x12 Bolt or M5x12 Bolt according to your TV/Monitor, connect VESA Plate together with D5 Washer into the mounting holes on the back of TV/Monitor, tighten with screwdriver.(Screwdriver needed but not included)
Step 2.3b
Select M4x16 Bolt or M5x16 Bolt according to your TV/Monitor, connect VESA
Plate together with D5 Washer and Spacer into the mounting holes on the back
of TV/Monitor, tighten with screwdriver.(Screwdriver needed but not included)
Step 3
Put the assembled TV/Monitor onto the Arm and ensure the stability, tighten the VESA plate using Top Screw.
Step 4
Pull the bottom cable slot cover to the VESA direction to detach it off the arm.
Step 5
Guide the cable through the cable slot and slide the cover back to arm.
Step 6
Adjust the Gas Spring Tension
- Adjust the gas spring tension with 6mm Allen Key.
- Insert the 6mm Allen Key into the adjusting hole and turn clockwise (-) to reduce gas spring tension, suitable for lighter screens.
- Insert the 6mm Allen Key into the adjusting hole and turn counter-clockwise (+) to increase gas spring tension, suitable for heavier screens.
For Heavier Monitors
For Lighter Monitors
Step 7
We support the technology that brings your home to life.
We offer high quality products, professional customer service, and
extensive technical support.
If you have any questions, please contact us.
1-844-SATTLER (18447288537)
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>