HuddleCamHD Large Base Camera Wall Mount Installation Guide
- June 7, 2024
- HuddleCamHD
Table of Contents
HCM-2
Large Base Camera
Wall Mount
Setup Guide
What’s Included
QTY 1—Large Wall Mount BK/WH
QTY 4—10-12 x 1″ Conical Plastic Anchor 1/4″ Drill Size (Fig 1, #1)
QTY 4—#10-16x 1 1/4″ PPH Sheet Metal Screw with Flat Washer (Fig 1, #2)
QTY 4—#6-32x 1″ PPH Machine Screw (Fig 1, #3)
Mounting Instructions
Step 1
For masonry or drywall wall:
Position Large wall mount (Fig 2) on wall and mark wall for anchor placement
(Fig 2, # 1). Predrill 1/4″ holes, minimum 1” deep.
For double gang electrical box:
Position over box with slots overlaying device mounting holes (Fig 2, #1) on box.
Step 2
For masonry or drywall wall:
Place included anchors (Fig 1, #1) in-wall and mount to anchors using included
10 sheet metal screws. (Fig 1, #2) For double gang electrical box: Mount to
box using #6 machine screws and washers. (Fig 1, #3)
Step 3
Drill hole in wall through rear exit opening for cable access, or use base
exit opening. (Fig 2, #2)
Step 4
Mount Camera to mount (Fig 2, #3) with included 1/4-20 machine screw. (Fig 1,
4) Utilize (0,1,2) 1/4” machine screw flat washers as required. (Fig 1, #4)
Note: 1/4” machine screw flat washers are to be used depending upon depth of thread insert in base of camera, in order to achieve a snug fit. Pass all cables through opening in mount (Fig 2, #2) and connect.
Mount Compatibility
HuddleCamHD
HC12X-HUDDLEVIEW
HC20X-SIMPLETRACK2
Generation 1 USB 3.0 HuddleCamHD cameras
Other Cameras…
This mount has been designed for use with most large based cameras utilizing a
1/4-20” mounting hole as can be found on SONY, Panasonic, Cisco, Polycom and
Vaddio cameras.
For more information on HuddleCamHD mounts and other products please visit: https://huddlecamhd.com
Rev 2.1
5/15/2020
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>