GAZELLE GC1220 12V Brushless 10 mm Drill Driver User Manual
- June 8, 2024
- GAZELLE
Table of Contents
GAZELLE GC1220 12V Brushless 10 mm Drill Driver
Product Usage Instructions
Charging the Batteries:
Before using the drill driver, ensure both battery packs are fully charged
using the provided battery charger.
Installing and Changing Drill Bits:
To install or change drill bits, follow these steps:
- Ensure the drill driver is turned off.
- Loosen the chuck by turning it counterclockwise.
- Insert the drill bit into the chuck and tighten by turning it clockwise.
- Ensure the bit is securely in place before operation.
Operating the Drill Driver:
To use the drill driver effectively:
- Select the desired speed and torque setting using the mode selectors.
- Press the variable speed trigger to start drilling or driving screws.
- Adjust the pressure on the trigger for control over the application.
- Utilize the forward/reverse control switch to change the direction of rotation.
- The LED light can be activated to illuminate dark workspaces.
- For safety, always wear appropriate protective gear when operating the tool.
Frequently Asked Questions:
-
Q: How do I change the torque setting on the GC1220 drill driver?
A: To adjust the torque setting, rotate the torque control ring to select from the available settings indicated on the tool. -
Q: Can I use the GC1220 drill driver for masonry drilling?
A: The GC1220 drill driver is recommended for wood and steel drilling. For masonry drilling, consider using a dedicated hammer drill for optimal results.
OVERVIEW
SCOPE OF DELIVERY
SPECIFICATION
- Power Source Cordless
- Voltage 12V
- Battery Capacity 2.0 Ah
- Motor Type Brushless
- Max. Torque Gear 1 35 Nm
- Max. Torque Gear 2 16 Nm
- No Load Speed 0 – 460 / 0 – 1600 RPM
- Chuck Capacity 10 mm
- Max. Screw Diameter 7 mm
- Torque Settings 20 + 1
- Max. Drilling Capacity (Wood) 20 mm
- Max. Drilling Capacity (Steel) 10 mm
- Weight 0.93 kg
- Length 17 cm
- Height 19 cm
sales@gazelleindustrial.com
www.gazelleindustrial.com