Logitech WONDERBOOM 3 Bluetooth Speaker User Manual
- June 7, 2024
- Logitech
Table of Contents
Logitech WONDERBOOM 3 Bluetooth Speaker User Manual
POWER
To get started with your WONDERBOOM 3, press the power button located on the top of your speaker. When powered on, WONDERBOOM 3 automatically reconnects to the last mobile device it was connected to. WONDERBOOM 3 will automatically turn itself off after 15 minutes of inactivity to save battery life. To pair WONDERBOOM 3 with your mobile device, press and hold the Bluetooth button until you hear the tone. Go to the Bluetooth settings on your mobile device and select WONDERBOOM 3 from the list.
CONNECT
To pair WONDERBOOM 3 with your mobile device, press and hold the Bluetooth
button until you hear the tone. Go to the Bluetooth settings on your mobile
device and select WONDERBOOM 3 from the list.
PLAY MUSIC
Once WONDERBOOM 3 is on and connected to your mobile device, just hit play to begin streaming your music. You can control the volume from your mobile device, or directly from your WONDERBOOM 3 by pressing the “+” or “-” button.
CONTROL MUSIC
You can control the music directly from your WONDERBOOM 3 without picking up your phone. To pause the stream, simply press the centre button located on the top of the speaker. Press it again to resume playing. Double-press the button will skip to the next track.
CHARGE
To charge your WONDERBOOM 3, plug the included USB cable into the micro-USB port located inside the weather door.
Warning
A wet or contaminated micro-USB connector may cause excessive heat or melting
and may lead to fire damage or personal injury. Always charge your speaker
with a clean, dry microUSB connector.
BATTERY LEVEL
You can check the battery level of your WONDERBOOM 3 by pressing both the
volume + and volume – buttons simultaneously. If you hear this tone, it means
that your WONDERBOOM 3 is roughly half full (or half empty).
{audio clip}
If you hear this tone, your WONDERBOOM 3 is running low on power and needs a
charge.
DOUBLE UP
Connect two WONDERBOOM 3 for a bigger sound. PRESS AND HOLD the centre button
on 1 speaker and wait for the sonification. While holding the centre button on
speaker 1, press the centre button on speaker 2 until you hear a pairing tone.
{Sound clip}
You could easily switch between ‘Party Louder’ mode and ‘Immersive Stereo’
mode by pressing the centre button. Press the Bluetooth button of one of the
two speakers to leave the DOUBLE-UP mode. If you hear this confirmation tone,
it means that you are in double sound mode. If you hear this confirmation
tone, it means that you are in stereo mode.
MULTI-HOST
WONDERBOOM 3 can simultaneously connect with up to two Bluetooth mobile
devices. Simply pair and connect each mobile device to WONDERBOOM 3, and then
you can take turns playing music from each device.
Still, Need help?
Our agents are here to help Monday -Friday from 7 AM – 5 PM PST. With two ways
to contact us, communicate in the way that you like best!
Shop
HYPERBOOM
MEGABOOM 3
BOOM 3
boom 3
WONDERBOOM 3
RETAILERS
Hours
Monday – Friday
7:00 AM – 5:00 PM PST
Learn
Press
Recycling
Heritage
Helpful Info
Download PDF:Logitech WONDERBOOM 3 Bluetooth Speaker User Manual
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>