SKIP HOP Dream Shine sleep trainer nightlight Owner’s Manual
- June 7, 2024
- SKIP HOP
Table of Contents
SKIP HOP Dream Shine sleep trainer nightlight Owner’s Manual
Adult Assembly Required.
WARNING: This is an
electric lamp, not a toy. To avoid risk of fire, burns, electric shock and
injury, it should not be played with or placed where small children can reach
it. To reduce the risk of electric shock: always unplug the appliance from the
electrical outlet immediately after using and before cleaning; do not reach
for an appliance that has fallen into water–unplug it immediately; do not
place or store appliance where it can fall or be pulled into a tub or sink; do
not place in or drop into water or other liquid. To reduce the risk of burns,
fire, electric shock or injury to persons: close supervision is necessary when
this appliance is used by or near children. Cord may be a strangulation
hazard. Keep out of reach of children. Do not use with extension cords. Always
use with adult supervision. The product is not to be connected to more than
recommended number of power supplies. Do not leave infant unattended with
product. Do not place product in crib. Inspect product before each use and
discard if damaged or worn. This product cannot be used without the battery
door. This product is not a toy. The transformer is not a toy. Products liable
to be cleaned with liquids are to be disconnected from the transformer before
cleaning. The product shall only be used with a transformer for toys. The
product is only to be connected to Class II equipment bearing the symbol .
Discard packaging materials properly. Please retain important information for
future reference.
CAUTION: Changes or
modifications not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment.
IMPORTANT SAFETY INSTRUCTIONS: Ensure USB cord is connected into item
first before inserting into power source. User should connect to 5V output
adapter (toy grade) 5.00 DC, 120mA. No serviceable or replacement parts
inside. Misuse can cause electrical shock. The ventilation should not be
impeded by covering the product with items, such as newspapers, tablecloths,
curtains, etc. No naked flame sources, such as lighted candles, should be
placed on the apparatus. Batteries (battery pack or batteries installed) shall
not be exposed to excessive heat such as sunshine, fire etc. The apparatus
shall not be exposed to dripping or splashing and that no objects filled with
liquids, such as vases, shall be placed on the apparatus. Do not use if liquid
has entered the product. Inspect entire product frequently and discard at
first sign of damage.
EC Rep: Fox Williams 10 Finsbury Square London EC2A 1AF, UK
FCC INFORMATION:
ICES-003 INFORMATION: CAN ICES-3 (B)/NMB-3(B):
© 2019 Skip Hop, Inc. 50 W 23 ST, NY, NY 10010
In the US: 888.782.9548 www.skiphop.com Meets or
exceeds applicable safety standards.
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation. Changes or
modifications not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on,the user is encouraged to try
and correct the interference by one or more of the following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and the receiver.
– Connect the equipment to an outlet on a circuit different from that to which
the receiver is connected.
– Consult the dealer or an experienced radio/TC technician for help.
CONTENTS:
Perfect for training your little one to go to bed on time, to stay in bed until it is time to get up—even at nap time— and for use as a comforting nightlight and soother.
POWER SOURCE:
The Sleep Trainer can be powered using batteries or by plugging it in using
the included USB cord and a power adapter
(not included).
Inserting the batteries:
Product requires 4 AA batteries, not included.
-
Loosen the battery door screw using a Phillips head screwdriver.
-
Open battery door compartment and insert 4 new AA (1.5V) Alkaline batteries into battery box. Be sure to insert with correct polarity.
-
Position the battery box correctly into battery compartment. Light will flash to indicate correct placement.
-
Position the battery door securely back into place and tighten with a screwdriver.
*Batteries should be replaced by an adult.
- Do not use without battery door properly attached.
Using the USB Cord :
Ensure USB cord is connected into item first before inserting into power source. Connect to 5V output adapter (toy grade) 5.00 DC, 120mA (power adapter not included).
QUICK SETUP:
Set the Time:
(when batteries or USB cord are inserted for the first time, the display will
read “12:00 AM”)
Wake Mode:
To activate Wake Mode, press “MODE” until arrow is under
Press and hold until a line appears under . Wake time defaults to 7am.
Sleep Mode:
To activate Sleep Mode, press “MODE” until arrow is under .
Press and hold until a line appears under . Sleep time defaults to 8pm.
Nap Mode: Nightlight/ Soother:
To begin a nap anytime, press and hold the Sun Button. Nap duration
defaults to 60 minutes.
Nightlight/Soother:
To turn on the Nightlight/Soother, press the Sun Button. Light and/or sound
stays on for 30 minutes.
Light & Sound:
- Brightness defaults to highest level (3)
- Sound defaults to Sound 1 (Lullaby)
- Volume defaults to highest level (3)
WAKE MODE:
10 Minutes before it is okay to get up in the morning, a warm yellow light starts to fade in. When it is time to get up, the light changes to green and music plays for 2 minutes, while the green light stays on for a total of 20 minutes, signaling that it is okay to get out of bed. If volume is set to L:00, no music will play.
Set the Wake Time
SLEEP MODE:
When it is time to go to bed at night, music plays for two minutes (unless volume is set to L:00) while a yellow light animation plays. When the music ends, the light turns red and stays on for 20 minutes, signaling that it is bed time.
Set the Sleep Time
NAP MODE:
10 Minutes before it is okay to get up from a nap, a warm yellow light starts to fade in. When naptime is over, the light changes to green and music plays for 2 minutes, while the green light stays on for a total of 20 minutes, signaling that it is okay to get out of bed. If volume is set to L:00, no music will play.
Set Nap Duration
Activate Nap Mode: Nap mode can be activated at any time. Press and hold the Sun Button for 2 seconds until you hear a beep. To cancel nap time, press and hold again.
SOOTHER & NIGHTLIGHT MODE:
- In WAKE, SLEEP and NAP modes, a melody will play automatically.
- For SOOTHER mode, you can choose from three sounds. Whichever volume is selected will work for all modes. To disable sound for all modes, set the volume to L:00.
Set the Sound and Volume
Soother sounds:
- Sd:01 = Lullaby
- Sd:02 = White Noise
- Sd:03 = Gentle Rain
Volume settings:
- L:00 = Sound Off
- L:01 = Lowest Setting
- L:02 = Medium Setting
- L:03 = Loudest Setting
Note: If you do not choose a volume level, it will default to the loudest setting. If you do not choose a song, it will default to Lullaby.
Set Nightlight Brightness
(you only have to do this once, it will remember your choice next time)
Activate Soother/ Nightlight: Press the Sun Button to toggle through the following choices:
- 1st press: Your chosen sound Plays (unless volume is set to L:00).
- 2nd press: Light comes on while sound is playing
- 3rd press: Sound turns off, light stays on
- 4th press: Light turns off
Light and/or sound stays on for 30 minutes.
CLEANING & CARE:
Unplug before cleaning. Clean with dry cloth only. To prolong the life of this product, remove batteries when toy is in storage. Do not drop on hard surfaces or expose to moisture. Do not submerge in water.
BATTERY INFORMATION:
At the end of product life, remove batteries from product by following the above battery replacement instructions. Always dispose of used batteries properly. See section on safety and disposal information.
- Batteries are to be inserted with the correct polarity.
- Do not burn batteries.
- Non-rechargeable batteries are not to be recharged. · Rechargeable batteries are only to be charged under adult supervision.
- Rechargeable batteries are to be removed from the toy before being charged. · Exhausted batteries are to be removed from the toy.
- The supply terminals are not to be short-circuited.
- Different types of batteries or new and used batteries are not to be mixed.
- Do not mix alkaline, standard (carbon-zinc), or rechargeable batteries.
CONSUMER INFORMATION: SAFETY AND DISPOSAL
At end of product life remove batteries from product by following the battery
replacement instructions. Substances used in batteries pose potential
environmental and health effects. Do not mix waste batteries with other waste.
Keep waste batteries separate. Do not dispose of by landfill or by
incineration. Return waste batteries to your point of purchase or recycle
center. Recycle all waste batteries per local regulation. Do not dispose of
Waste Electrical Electronic Equipment (WEEE), including batteries, in unsorted
municipal waste; collect separately. Dispose of at WEEE collection sites per
local regulation. WEEE contains chemicals that are hazardous to the
environment and human health. The end-user’s participation is critical to the
success of WEEE collection.
Product is for indoor use only
Direct current only
Please read all instructions. Rating Label is located on the bottom of the product.
USB
Direct current output from USB connector. + Positive terminal / – Negative terminal
FCC
Direct current power input connector on Sleep Trainer.The positive
connector is internal and the negative connector is exterior.
The power adapter is a class ll electrical device.
Dispose of in accordance with local law. Separate collection for WEEE.
EU Compliance
AS/NZS RCM
Transformer Toy
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>