SKIP HOP 185250-07 Dream and Shine Sleep Trainer Owner’s Manual
- June 12, 2024
- SKIP HOP
Table of Contents
SKIP HOP 185250-07 Dream and Shine Sleep Trainer Owner’s Manual
WARNING: This is an electric lamp, not a toy. To avoid risk of fire, burns, electric shock and injury, it should not be played with or placed where small children can reach it. To reduce the risk of electric shock: always unplug the appliance from the electrical outlet immediately after using and before cleaning; do not reach for an appliance that has fallen into water—unplug it immediately; do not place or store appliance where it can fall or be pulled into a tub or sink; do not place in or drop into water or other liquid. To reduce the risk of burns, fire, electric shock or injury to persons: close supervision is necessary when this appliance is used by or near children. Cord may be a strangulation hazard. Keep out of reach of children. Do not use with extension cords. Always use with adult supervision. The product is not to be connected to more than recommended number of power supplies. Do not leave infant unattended with product. Do not place product in crib. Inspect product before each use and discard if damaged or worn. This product cannot be used without the battery door. This product is not a toy. The transformer is not a toy. Products liable to be cleaned with liquids are to be disconnected from the transformer before cleaning.The product shall only be used with a transformer for toys. The product is only to be connected to Class II equipment bearing the symbol . Discard packaging materials properly. Please retain important information for future reference.
CAUTION: Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment
IMPORTANT SAFETY INSTRUCTIONS: Ensure USB cord is connected into item first before inserting into power source. User should connect to 5V output adapter (toy grade) 5.00 DC, 120mA. No serviceable or replacement parts inside. Misuse can cause electrical shock. The ventilation should not be impeded by covering the product with items, such as newspapers, tablecloths, curtains, etc. No naked flame sources, such as lighted candles, should be placed on the apparatus. Batteries (battery pack or batteries installed) shall not be exposed to excessive heat such as sunshine, fire etc. The apparatus shall not be exposed to dripping or splashing and that no objects filled with liquids, such as vases, shall be placed on the apparatus. Do not use if liquid has entered the product. Inspect entire product frequently and discard at first sign of damage.
Skip Hop, Inc.
100 W 33 ST, STE 1125, NY, NY 10001
In the US: 888.782.9548
www.skiphop.com
FCC INFORMATION:
ICES-003 INFORMATION:
CAN ICES-3 (B)/NMB-3(B):
CAUTION: Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference recieved, including interference that may cause undesired operation.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on,the user is encouraged to try and correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and the receiver.
- Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
IMPORTANT! Keep instructions for future use.
CONTENTS
Perfect for training your little one to go to bed on time, to stay in bed until it is time to get up—even at nap time— and for use as a comforting nightlight and soother
Sleep Trainer
USB Cord
POWER SOURCE:
We recommend to use with the included USB cord and a power adapter (not included). If you choose to use batteries, battery life is 1 week of continuous use.
I nserting the batteries:
Product requires 4 AA batteries, not included.
-
Loosen the battery door screw using a Phillips head screwdriver.
-
Open battery door compartment and insert 4 new AA (1.5V) Alkaline batteries into battery box. Be sure to insert with correct polarity
-
Position the battery box correctly into battery compartment. Light will flash to indicate correct placement
-
Position the battery door securely back into place and tighten with a screwdriver. Batteries should be replaced by an adult. Do not use without battery door properly attached.
Using the USB Cord
Ensure USB cord is connected into item first before inserting into power
source. Connect to 5V output adapter (toy grade) 5.00 DC, 120mA (power adapter
not included).
QUICK SETUP
Set the Time:
(when batteries or USB cord are inserted for the first time, the display will
read “12:00 AM”)
Wake Mode:
To activate Wake Mode, press “MODE” until arrow is under WAKE. Press and hold “SET“ until a line appears under WAKE. Wake time defaults to 7am
Sleep Mode:
To activate Sleep Mode, press “MODE” until arrow is under SLEEP. Press and hold “SET“ until a line appears under SLEEP. Sleep time defaults to 8pm.
Nap Mode:
To begin a nap anytime, press and hold the Sun Button. Nap duration defaults to 60 minutes.
Nightlight/ Soothe
To turn on the Nightlight/Soother, press the Sun Button. Light and/or sound stays on for 12 hours or until wake time sequence. Press sun button at any time to stop the lights/sounds
Light & Sound:
- Brightness defaults to highest level (3)
- Sound defaults to Sound 1 (Lullaby)
- Volume defaults tohighest level (3)
WAKE MODE
10 Minutes before it is okay to get up in the morning, a warm yellow light starts to fade in. When it is time to get up, the light changes to green and music plays for 2 minutes, while the green light stays on for a total of 2 hours, signaling that it is okay to get out of bed. If volume is set to L:00, no music will play
Set the Wake Time
SLEEP MODE
When it is time to go to bed at night, music plays for two minutes (unless volume is set to L:00) while a yellow light animation plays. When the music ends, the light turns red (signaling that it is bed time) and stays red for 12 hours or until WAKE TIME SEQUENCE starts.
Set the Sleep Time
CONTENTS: NAP MODE
10 Minutes before it is okay to get up from a nap, a warm yellow light starts to fade in. When naptime is over, the light changes to green and music plays for 2 minutes, while the green light stays on for a total of 2 hours, signaling that it is okay to get out of bed. If volume is set to L:00, no music will pl
Set Nap Duration
Activate Nap Mode: Nap mode can be activated at any time. Press and hold the Sun Button for 2 seconds until you hear a beep. The red light will be activated for the duration of the nap time set. To cancel nap time, press and hold again.
SOOTHER & NIGHTLIGHT MODE
- In WAKE, SLEEP and NAP modes, a melody will play automatically.
- For SOOTHER mode, you can choose from three sounds. Whichever volume is selected will work for all modes. To disable sound for all modes, set the volume to L:00.
Set the Sound and Volume
Soother sounds:
- Sd:01 = Lullaby
- Sd:02 = Gentle Rain
- Sd:03 = White Noise
Volume settings:
- L:00 = Sound Off
- L:01 = Lowest Sett ng
- L:02 = Medium Setting
- L:03 = Loudest Setting
Note: If you do not choose a volume level, it will default to the loudest setting. If you do not choose a song, it will default to Lullaby.
Set Nightlight Brightness
(you only have to do this once, it will remember your choice next time)
Activate Soother/ Nightlight: Press the Sun Button to toggle through the following choices:
- 1st press: Your chosen sound Plays (unless volume is set to L:00).
- 2nd press: Light comes on while sound is playing
- 3rd press: Sound turns off, light stays on
- 4th press: Light turns of
Light and/or sound stays on for 12 hours or until wake time sequence. Press sun button at any time to stop the lights/sounds
CLEANING & CARE:
Unplug before cleaning. Clean with dry cloth only. To prolong the life of this product, remove batteries when toy is in storage. Do not drop on hard surfaces or expose to moisture. Do not submerge in water.
BATTERY INFORMATION:
At the end of product life, remove batteries from product by following the above battery replacement instructions. Always dispose of used batteries properly. See section on safety and disposal information. • Batteries are to be inserted with the correct polarity.
- Do not burn batteries.
- Non-rechargeable batteries are not to be recharged.
- Rechargeable batteries are only to be charged under adult supervision.
- Rechargeable batteries are to be removed from the toy before being charged.
- Exhausted batteries are to be removed from the toy.
- The supply terminals are not to be short-circuited.
- Different types of batteries or new and used batteries are notto be mixed.
- Do not mix alkaline, standard (carbon-zinc), or rechargeable batteries.
CONSUMER INFORMATION: SAFETY AND DISPOSAL
At end of product life remove batteries from product by following the battery replacement instructions. Substances used in batteries pose potential environmental and health effects. Do not mix waste batteries with other waste. Keep waste batteries separate. Do not dispose of by landfill or by incineration. Return waste batteries to your point of purchase or recycle center. Recycle all waste batteries per local regulation. Do not dispose of Waste Electrical Electronic Equipment (WEEE), including batteries, in unsorted municipal waste; collect separately. Dispose of at WEEE collection sites per local regulation. WEEE contains chemicals that are hazardous to the environment and human health. The end-user’s participation is critical to the success of WEEE collection.
Product is for indoor use only
Direct current only.
Please read all instructions. Rating Label is located on the bottom of the
product}
USB
Direct current output from USB connector. + Positive terminal / – Negative
terminal
FCC
Directcurrent power inputconnector on Sleep Trainer. The positive connector
isinternal and the negative connector is exterior.
The power adapter is a classll electrical device
Dispose of in accordance with local law. Separate collection for WEEE.
EU Compliance
UK Conformity Assessed mark
AS/NZS RCM
Transformer Toy
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>