SKIP HOP 185250-07 Sleep Trainer Owner’s Manual
- June 2, 2024
- SKIP HOP
Table of Contents
SKIP HOP 185250-07 Sleep Trainer
Adult Assembly Required.
WARNING : This is an electric lamp, not a toy. To avoid risk of fire, burns, electric shock, and injury, it should not be played with or placed where small children can reach it.To reduce the risk of electric shock: always unplug the appliance from the electrical outlet immediately after using and before cleaning; do not reach for an appliance that has fallen into water—unplug it immediately; do not place or store the appliance where it can fall or be pulled into a tub or sink; do not place in or drop into water or other liquid.To reduce the risk of burns, fire, electric shock or injury to persons: close supervision is necessary when this appliance is used by or near children. Cord may be a strangulation hazard. Keep out of reach of children. Do not use with extension cords. Always use it with adult supervision. The product is not to be connected to more than the recommended number of powersupplies. Do not leave the infant unattended with the product. Do not place the product in the crib. Inspect the product before each use and discard if damaged or worn. This product cannot be used without the battery door.
This product is not a toy. The transformer is not a toy. Products liable to be cleaned with liquids are to be disconnected from the transformer before cleaning.The product shall only be used with a transformer for toys. The product is only to be connected to ClassII equipment bearing the symbol. Discard packaging materials properly. Please retain important information for future reference.
CAUTION : Changes or modifications not expressly approved by the partyresponsible for compliance could void the user’s authority to operate the equipment.
IMPORTANT SAFETY INSTRUCTIONS: Ensure the USB cord is connected to the item first before inserting it into the power source. Usershould connect to 5V output adapter (toy grade) 5.00 DC, 120mA. No serviceable or replacement parts inside. Misuse can cause electrical shock. The ventilation should not be impeded by covering the product with items,such as newspapers, tablecloths, curtains, etc. No naked flame sources, such as lighted candles, should be placed on the apparatus. Batteries(battery pack or batteries installed)shall not be exposed to excessive heat such as sunshine, fire etc. The apparatus shall not be exposed to dripping or splashing and that no objects filled with liquids, such as vases, shall be placed on the apparatus. Do not use if the liquid has entered the product. Inspect the entire product frequently and discard at the first sign of damage.
Read all instructions before using the Sleep Trainer.
IMPORTANT! Keep instructions for future use.
CONTENTS
Perfect for training your little one to go to bed on time, to stay in bed until it is time to get up—even at nap time— and for use as a comforting nightlight and soother.
POWER SOURCE:
We recommend using it with the included USB cord and a power adapter (not
included).
If you choose to use batteries, battery life is 1 week of continuous use
Inserting the batteries
The product requires 4 AA batteries, not included.
- Loosen the battery door screw using a Phillips head screwdriver
- Open the battery door compartment and insert 4 new AA (1.5V)Alkaline batteries into the battery box. Be sure to insert with the correct polarity.
- Position the battery box correctly into the battery compartment. Light will flash to indicate the correct placement.
- Position the battery door securely back into place and tighten it with a screwdriver.
- Batteries should be replaced by an adult.
- Do not use without the battery door properly attached.
Using the USB Cord
Ensure the USB cord is connected into the item first before inserting it into a power source. Connect to 5V output adapter (toy grade) 5.00 DC, 120mA (power adapter not included).
QUICK SETUP
Set the Time
(when batteries or USB cord are inserted for the first time, the display will read “12:00 AM”)
Wake Mode: To activate Wake Mode, press “MODE” until the arrow is under WAKE. Press and hold “SET“ until a line appears to undertake. Wake time defaults to 7 am
Sleep Mode: To activate Sleep Mode, press “MODE” until the arrow is under SLEEP. Press and hold “SET“ until a line appears under SLEEP. Sleep time defaults to 8 pm.
Nap Mode: To begin a nap anytime, press and hold the Sun Button. Nap duration defaults to 60 minutes.
Nightlight/ Soother: To turn on the Nightlight/Soother, press the Sun Button. Light and/or sound stays on for 12 hours or until the wake time sequence. Press the sun button at any time to stop the lights/sounds.
Light & Sound:
- Brightness defaults to highest level (3)
- Sound defaults to Sound 1 (Lullaby)
- Volume defaults to highest level (3)
WAKE MODE
10 minutes before it is okay to get up in the morning, a warm yellow light starts to fade in. When it is time to get up, the light changes to green and music plays for 2 minutes, while the green light stays on for a total of 2 hours, signaling that it is okay to get out of bed. If the volume is set to L:00, no music will play.
Set the Wake Time
SLEEP MODE
When it is time to go to bed at night, music plays for two minutes (unless the volume is set to L:00) while a yellow light animation plays. When the music ends, the light turns red (signaling that it is bedtime) and stays red for 12 hours or until WAKE TIME SEQUENCE starts.
Set the Sleep Time
NAP MODE
10 minutes before it is okay to get up from a nap, a warm yellow light starts to fade in. When naptime is over, the light changes to green and music plays for 2 minutes, while the green light stays on for a total of 2 hours, signaling that it is okay to get out of bed. If the volume is set to L:00, no music will play.
Set Nap Duration
Activate Nap Mode: Nap mode can be activated at any time. Press and hold the Sun Button for 2 seconds until you hear a beep. The red light will be activated for the duration of the nap time set. To cancel nap time, press and hold again
SOOTHER & NIGHTLIGHT MODE:
- In the WAKE, SLEEP and NAP modes, a melody will play automatically.
- For the SOOTHER mode, you can choose from three sounds. Whichever volume is selected will work for all modes. To disable sound for all modes, set the volume to L:00
Set the Sound and Volume
Soother sounds:
- Sd :01 = Lullaby
- Sd :02 = Gentle Rain
- Sd :03 = White Noise
Volume settings:
- L :00 = Sound Off
- L :01 = Lowest Setting
- L :02 = Medium Setting
- L :03 = Loudest Setting
Note: If you do not choose a volume level, it will default to the loudest setting. If you do not choose a song, it will default to Lullaby.
Set Nightlight Brightness
(you only have to do this once, it will remember your choice next time)
Activate Soother/ Nightlight: Press the Sun Button to toggle through the following choices:
- 1st press : Your chosen sound Plays (unless the volume is set to L:00).
- 2nd press : Light comes on while the sound is playing
- 3rd press : Sound turns off, light stays on
- 4th press : Light turns off
Light and/or sound stays on for 12 hours or until the wake time sequence.
CLEANING & CARE
Unplug before cleaning. Clean with a dry cloth only. To prolong the life of
this product, remove batteries when toy is in storage.
Do not drop on hard surfaces or expose to moisture. Do not submerge in water.
BATTERY INFORMATION:
At the end of product life, remove batteries from the product by following the above battery replacement instructions. Always dispose of used batteries properly. See the section on safety and disposal information.
- Batteries are to be inserted with the correct polarity.
- Do not burn batteries.
- Non-rechargeable batteries are not to be recharged.
- Rechargeable batteries are only to be charged under adult supervision.
- Rechargeable batteries are to be removed from the toy before being charged.
- Exhausted batteries are to be removed from the toy.
- The supply terminals are not to be short-circuited.
- Different types of batteries or new and used batteries are not to be mixed. • Do not mix alkaline, standard (carbon-zinc), or rechargeable batteries.
Press the sun button at any time to stop the lights/sounds.
CONSUMER INFORMATION: SAFETY AND DISPOSAL
At the end of product life remove batteries from a product by following the battery replacement instructions. Substances used in batteries pose potential environmental and health effects. Do not mix waste batteries with other waste. Keep waste batteries separate. Do not dispose of by landfill or by incineration. Return waste batteries to your point of purchase or recycle center. Recycle all waste batteries per local regulations. Do not dispose of Waste Electrical Electronic Equipment (WEEE), including batteries, in unsorted municipal waste; collect them separately. Dispose of at WEEE collection sites per local regulation. WEEE contains chemicals that are hazardous to the environment and human health. The end-user’s participation is critical to the success of WEEE collection.
The product is for indoor use only.
Direct current only.
Please read all instructions. The rating Label is located on the bottom of the product.
USB
Direct current output from USB connector. + Positive terminal / – Negative terminal
FCC
Direct current power input connector on Sleep Trainer. The positive connector is internal and the negative connector is exterior.
The power adapter is a class ll electrical device.
Dispose of in accordance with local law. Separate collection for WEEE.
EU Compliance
UK Conformity Assessed mark
AS/NZS RCM
TransformerToy
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>