NoiseMeters SE3EAR Advanced Noise Warning Sign User Guide
- June 4, 2024
- NoiseMeters
Table of Contents
SE3EAR Advanced Noise Warning Sign
Quick User Guide
Rev: 0.6
Unpack, familiarise and check you have the following contents
Install Software
The software is supplied on a small NoiseMeters USB memory stick (item 2). Save a copy of the USB memory stick contents and then delete the files. This USB stick can be used for downloading data from the SE3EAR. Alternatively download from the following link: https://support.noisemeters.com/downloads/soundear3/
2.1 Important: Licence information & network / IT dept permissions
The SoundEar3 software does not require a license so it can be installed on
multiple computers at no additional cost.
Networked systems: The SoundEar3 software must be installed with full admin
rights. Network permissions/constraints must allow a USB memory device to be
plugged into the user’s computer. During installation set ‘User access rights
to ‘Program data’ and ‘Data and Reports’ Folders. If any of the above is not
possible you must use a ‘standalone computer’.
Options to configure SE3EAR
Recommended: Set up the SE3EAR using the SoundEar3 software provided.
Alternatively, manually create a simple setup using the ‘Manual touch keypad
buttons’ on the SE3EAR. This is quick and basic allowing the creation of a
simple ‘Threshold level’, in decibels (dB), for the Red lights, and the Amber
lights will trigger 5 dB below this.
3.1 Configuration using the SoundEar3 software provided
3.2 Set the time, threshold trigger levels
Install the SE3EAR
References
- Sound Level Meters and Noise Dosimeters in the UK from NoiseMeters
- Sound Level Meters and Noise Dosimeters from NoiseMeters Inc
- NoiseMeters Software Download - SoundEar3
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>