Shenzhen Delux Industry M618ZD Vertical Mouse User Manual

Shenzhen Delux Industry M618ZD Vertical Mouse

Thank you for choosing our wireless vertical mouse.
Please read the user manual carefully when using this product.

Contents

• Wireless vertical mouse X1
• User manual –X1
• USB Nano receiver (stored in the battery compartment) –X1
• 1.6m Type-C charging cable —-X1

Button Function

1. Forward
2. DPl cycle
3. Backward
4. Scroll wheel
5. Left-click
6. Right-click
7. Charging indicator
8. ON/OFF button
9. Mode Switch Key
10. Pairing Key
11. USB receiver

Features

• Ergonomic vertical left-handed design
• Tri-mode connection
• 1000mAh built-in Li-ion battery

Specification

• Connection
  • Wired+2.4G
• DPI
  • 800/1200/1600/2400/4000
• Polling rate
  • 125Hz

Connection

1. Mode Switching
   When sliding the Mode Switch Key to 2.4G mode, the indicator will flash green color. When sliding the Mode Switch Key to BT mode, the indicator will flash blue color. When plugging the Type-C cable into the computer, the mouse will enter wired mode and charge the battery at the same time. When charging, the indicator will light up with red color, and light off when fully charged.

2. Match Way

3. 2.46 Mode: Slide the Mode Switch Key to 2.4G mode, press the Pairing Key for 3s, the indicator will flash green color, then plug the USB receiver within 1 minute and the mouse will program automatically.

4. Notes:

   • The indicator light will flash once after shifting the DPI to the first grade, will flash twice after shifting the DPI to second grade, etc. 5 grades in total.
   • Press the scroll wheel+ backward button at the same time to switch among 5 lighting effects: Streaming, Neon, Breathing, Flicker, Led off.
   • When using the mouse, the corresponding mode indicator light flashes constantly to indicate that the battery is low, please charge it with a suitable device in time.

5. Debugging Tips

   • Make sure the receiver is plugged in the USB p ort.
   • Make sure the distance between mouse and device is 1 Om.
   • Make sure the ON/OFF button are slid to the “ON” position

FCC Caution

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:

1. This device may not cause harmful interference, and
2. this device must accept any interference received, including interference that may cause undesired operation.
   Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.

This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

The device has been evaluated to meet general RF exposure requirements. The device can be used in portable exposure conditions without restriction.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>