HuddleCamHD Camera Ceiling Mount Small Base User Guide
- June 7, 2024
- HuddleCamHD
Table of Contents
HCM-1C
Camera Ceiling Mount – Small Base
Set-Up Guide
What’s Included:
- Qty 1 – Ceiling Mount
- Qty 1 – 1/4-20 mounting screw
- Qty 1 – 10/32 x 1/4” cup point set screw
- Qty 1 – 3/32” long arm hex wrench (for set screw)
- Qty 2 – 1/4” washers
Step 1:
Screw 1” NPT pipe or pipe nipple to a properly installed mounting plate or
pipe flange like that shown below. Tighten until the pipe can no longer be
tightened with a pipe wrench. If using a 1.5” plate or flange, you must use a
1.5”-1” reducing bushing, like shown below.
*Notes:
Plate/flange, reducer bushing, & 1” NPT pipe or nipple not included.
Plate/flange must be installed according to applicable construction codes.
Step 2:
Screw mount onto pipe securely, engaging a minimum of ½” of pipe into mount.
When aligned to the desired location, tighten the set screw to 30-36 in-lbs of
torque (this is approximately when the set screw will stop moving and the long
arm – of the provided wrench – will then only bend).
Step 3:
Mount camera upright to top of mount or inverted to bottJom of mount using
included ¼-20 bolt through a slot in mount. Use 0-2 of the provided washers as
required to make the bolt snug, so that camera is held in the desired
position.
Step 4:
Run cabling through pipe or dress to the outside of pipe for a clean
installation aesthetic.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>