TBI PRO Indoor BUG Zapper User Guide
- June 7, 2024
- TBI PRO
Table of Contents
QUICKSTART GUIDE
SAFETY NOTICES
If you will have any questions, feel free to contact us by phone number:
(800) 674-92-29 (Free)
or via email:support@tbi-pro.com
INSTALLING
Suggested suspension height:
keep the product hanged at a height of 4 ft (1.2 m) at a distance of 1 ft
(0.3m) from the wall. The device can be mounted on the ceiling using a hanging
chain. For installation, drill holes with a 9 mm drill. Depth 80-90 mm.,
Insert into the dowel holes.
Into dowel are screwed hooks, on which an insecticidal lamp is subsequently
suspended using a chain.
HOW TO REPLACE THE LIGHT TUBES
STEP 1
Unplug the power cord.
STEP
2
ENSURE screwdriver and hands are dry! Discharge the internal
electrified grid by using a dielectric screwdriver: Insert the metal tip of
the screwdriver onto the internal electrified grid. You may hear and see a
zap. insert the metal tip of the screwdriver onto the internal electrified
grid until there are no zaps. 
STEP 3
Flip the device 180 degrees to the back of the device. Press the black
protective grid down to the bottom. The protective grid is spring-loaded, then
lower it down.
STEP 4
Rotate gently the tubes until you see the golden tube plug from the tube
socket gap. When you see the golden tube plug connector in the tube socket
gap, then you have scrolled everything correctly. After that, carefully remove
the lamp from the connector.
ATTENTION: When replacing the lamp tube, you should hold the lamp head
part. Do not grab the transparent glass tube to avoid leaving fingerprints,
sweat, and dirt, which will affect the ultraviolet transmission effect.
STEP 5
Insert the replacement tubes with new extra free 2 tubes. Insert the
replacement tubes with gold connectors into the tube socket gap, and gently
scroll clockwise.
STEP 6
Close the protective grid. Press on it so that it closes. Insert the
electrical plug into an outlet turn on the bug zapper to check the light of
the tubes.
HOW TO CHANGE ATTRACTANT
STEP 1
Unplug the power cord.
STEP 2
Remove the Bug Tray.
STEP 3
Remove the attractant cartridge from the sealed pouch and remove the
protective cover from the face of the cartridge.
Avoid touching the openings in the cartridge and always wash your hands
thoroughly after contact.
STEP 4
Place the attractant at the spot marked in the bug tray on the picture. Wash
hands thoroughly after handling.
Back the Bug tray in the Bug Zapper bottom.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>