AEPREK Solar Garage Light User Manual

June 7, 2024
AEPREK

AEPREK Solar Garage Light User Manual
AEPREK Solar Garage Light

Recommendations

  • Please charge the light for 4—5 hours before the first
  • This product has a battery, please keep away from the fire source to avoid explosion
  • It is not allowed to disassemble solar panels and batteries without
  • Solar panels should be placed in a place exposed to sunlight, and the angle should be adjusted to get enough
  • Please keep the surface of solar panel clean. It is recommended to clean it every 2 months to make charging Master and stronger.

Product Features

  1. This light is an energy—saving portable solar charging and lighting product. It is easy to install, free of wiring and zero electricity cost
  2. This product can be widely used in rural roads, trails courtyards, garages, barns, gardens, orchards, fishing grounds and other places where it is not convenient to use.
  3. After fully charged, the light can be used separately, suitable to be used as camping and emergency.

Package Contact

  1. Package Contact
    1. Package Contact
  2. Package Contact
  3. Package Contact
  4. Package Contact

Warm Tip

Please check the package when receiving the goods. If any missing or defective parts are found, please contact us for help.

Remote Controller Introduction

  1. Power ON
  2. Power OFF
  3. 1 Hour Lighting
  4. 2 Hours Lighting
  5. 4 Hours Lighting
  6. 6 Hours Lighting TIMER OFF
  7. TIMER OFF
  8. .Auto ON/OFF
  9. Dimming+
  10. Dimming
    Remote Controller Introduction

Function Introduction

Switch On & Off

ON: Power on button. Press it and the light is on.
OFF: Power off button. Press it  and can turn off the light under both 2 modes

Timing Function

1H/2H/4H/6H: Timing button. After pressing the corresponding number button, the light flashes once and keeps on for a specific period of time.
TIMER OFF: Turn off regularly, and the light flashes twice, indicating that it is canceled regularly.

Note:

  1. The timing function  will  only work  on the first  time, not for the second time and after. For example, i1′ the timing is pressed 1’or 1H frost, pressing 1 H or 2H/3H/4H again  will not work when the middle button is not pressed to cancel the timing closure, and the timing will be calculated as 1H for the first time. To reset the timing, press to cancel the timing before setting the timing.
  2. In the light control mode, the timer function starts counting down when it lights up. 24—hour cycle timing in no light control mode.)

Brightness Adjustment

DIM+/DIM —: Dimming button. You can adjust the brightness of the light according to your needs. There are 4 levels: 25%, 50%, 75%, 100%.

Working Mode Selection

AUTO ON/OFF: Switch button  for  light—sensitive automatic control mode and manual  control mode. Press  the AUTO  button to turn on the light—sensitive control mode: during the  day, the light  will be off  and the  system  will automatically  charge.  At night, the light will light up automatically; Press the AUTO  button again. After the light flashes 3 times, the light is on. At this time, the  light—sensitive control mode is turned  off  and the normal mode is switched.

Charging Methods

  1. Solar powered: install the solar panel in the direct sunlight place to charge the battery(6—8 hours, it will take longer in rainy days).
    Charging Methods

  2. USB charging: use 5V/1—3.6A charging devices to charge the light (3.5—4 hours).

Specifications

LED Quantity 96pcs highlight LED lamp bead
Lumens 800Im
LED Light 3.7V/7W
LED Light Material PC+ABS
4 Brightness Level 100% \ 75% \ 50% \ 25%
5 Lighting Modes 1H/2H/4H/6H + Constant light
Remote Distance 8—1 0 meters
Waterproof Level IP65
Solar Panel 6V/3.5W
Solar Panel Material Monocrystal line Silicon
Color Temperature SSOOK
Battery Capacity 4400mAh
Battery Quantity 2pcs(2200mAh*2)
Battery Type 18650 Lithium Battery
Battery Power 3.7V/16W
Charging Time Solar Powered: 6—8h

USB Cha rging: 3.5—4h

Working Time| 15—30h

( 1 00% brightness: 6—8h

75% brightness: 8—1 2h

50%   brightness: 1 2—15 h

25% brightness: 30h)

Cable Length| Connection cord: 5M/16.5ft;
USB cable| 30 cm
2 Control Mode| Light Sensor/Switch Control
2 Charging Methods| Solar Powered/USB Charging
Working Temperature| —31 °F +11 3°F/—35°C +45°C

Troubleshooting

Trouble Reason Analysis Solution
The light doesn’t work  
  • Connect the solar panel to the light and Run out of leave it under the battery sunlight to charge for at least 8 hour or use USB to charge it for 4 hour

In light sensor control mode, the light is in bright place|

  • Cover the solar panel to turn on the light
  • Press the AUTO button to switch to manual remote control mode. It can also be lit during the day.

The remote controller has no response| Remote control distance is too far|

  • Aim the remote controller at the receiver of the light, and the remote control distance is within 8-10 meters

The remote controller runs out of power|

  • Replace battery

Fail to charge| Defective solar panel/ battery|

  • please ease contact us for help

The solar panel gets dirty|

  • Recommend to keep the surface of solar panel clean

Battery life gets shorter and shorter| Solar panels don’t get enough sunlight to charge|

  • Ensure that the solar panel is installed in a place that can get sufficient sunlight, and no shelter between 9:00 and 15:00 per day.
  • If the solar light doesn’t get enough sunlight in rainy days, it can automatically return to the best working state after the weather cleared the next day and obtaining enough sunlight.
  • Recommend to clean the solar panel every 2 months to make charging faster and stronger. If the surface of the solar panel is not cleaned for a long time, the solar charging efficiency will be affected.

 | Defective battery|

  • Please contact us for help.

The light keeps flashing| The light—sensitive system cannot tell whether it is day or night

|

  • Cover the solar panel to create a dark environment
  • Press AUTO to switch to manual control mode, and then switch to light—sensitive automatic mode after completely dark.

 | IC problem|

  • When the solar panel is not connected, the light still flashes, so there may be something wrong with the IC. Please contact us for help

Turn on the light and only for a while at a time, then stop lighting| Battery protection|

  • This is the normal battery low—power protection function of solar light, not the product quality problem, and it can be restored to normal after charging without maintenance.
  • This is the same as the automatic shutdown of the mobile phone when it is out of power

Unavailable after a period of time| The battery has not been charged for a long time, and it needs to be reactivated|

  • Use USB to charge the light for 4 hours.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals