EKVIP 022421 String Lights Instruction Manual
- June 3, 2024
- EKVIP
Table of Contents
EKVIP 022421 String Lights
SAFETY INSTRUCTIONS
- Do not connect the product to the mains power supply while the product is still in the pack.
- Designed for indoor and outdoor use.
- Check that no light sources are damaged.
- Do not connect two or more string lights together.
- No part of the product can be replaced or repaired. The whole product must be discarded if any part is damaged.
- This string of lights must only be used together with the supplied transformer and must never be connected directly to the mains supply without a transformer.
- The product is not intended to be as general lighting.
WARNING!
The string of lights may only be used if all seals are fitted correctly.
Symbols
- Read the instructions.
- Class III.
- Approved as per applicable directives.
- Recycle a discarded product in accordance with applicable regulations.
TECHNICAL DATA
- Rated voltage, in 230 V ~ 50 Hz
- Rated voltage, out 31 VDC
- Output 2 W
- Bulbs 80
- Protection rating IP44
- Size L8.1 m
PRODUCT INFORMATION SHEET
| Supplier’s name or trademark: | EKVIP |
|---|---|
| Supplier’s address (a): | Jula AB, Box 363, 532 24 SKARA |
| Model identifier: | 022421 |
| Type of light source: | LED |
| Lighting technology used: | LED |
Light source connected to mains supply or light source not connected to mains supply:| ****
NMLS
| ****
Connected light source (CLS):
| ****
no
Colour-tuneable light source:| no| Envelope:| –
High luminance light source:| no| |
Anti-glare shield:| no| Dimmable:| no
Product parameters
Parameter| Value| Parameter| Value
General product parameters:
Energy consumption in on-mode (kWh/1000 h)| 2| Energy efficiency class| F
Useful luminous flux (Φuse), indicating if it refers to the flux in a sphere
(360˚), in a wide cone (120˚) or in a narrow cone (90˚).| ****
190 in sphere (360°)
| Correlated colour temperature, rounded to the nearest 100 K, or the range of correlated colour temperatures, rounded to the nearest 100 K, that can be set.| ****
2 700
On-mode power (Pon), expressed in W.| ****
2,0
| Standby power (Psb), expressed in W and rounded to the second decimal.|
0,00
Networked standby power (Pnet) for CLS, expressed in W and rounded to the second decimal.| ****
–
| Colour rendering index, rounded to the nearest integer, or the range of CRI- values that can be set.| ****
80
Outer dimensions without separate control gear, lighting control parts and non-lighting control parts, if any (millimetre).| Height| –| ****
Spectral power distribution in the range 250 nm to 800 nm, at full-load.
| ****
See image in last page
Width| 8 000
Depth| –
Claim of equivalent power (c)| –| If yes, equivalent power (W)| –
| | ****
Chromaticity coordinates (x and y)
| 0,480
0,437
Parameters for LED and OLED light sources:
R9 colour rendering index value| 12| Survival factor| 1,00
The lumen maintenance factor| 0,96| |
Parameters for LED and OLED mains light
sources:
Displacement factor (cos φ1)| –| Colour consistency in mcadam ellipses| 6
Claims that an LED light source replaces a fluorescent light source without
integrated ballast of a particular wattage.| ****
-(b)
| ****
If yes then replacement claim (W)
| ****
–
Flicker metric (Pst LM)| –| Stroboscopic effect metric (SVM)| –
