OLIGHT Warrior X Turbo User Manual

OLIGHT Warrior X Turbo User Manual

Thank you for purchasing this Olight Product. Please read this manual carefully before use and keep it for future reference!

IN THE BOX

1. Warrior X Turbo (With Battery)
   9

2. USB Magnetic Charging Cable
   

3. Holster
   

4. Silicone Tactical Grip Ring

5. Lanyard
   

SPECIFICATIONS

HIGH

LOW

• 1000m
• 250,000cd
• 1.5m
• IPX8
• (L)6.18 (D)2.28in (L)157 (D)58mm
• 10.37oz / 294g (Including Battery)

All above specifications are test results based on ANSI/NEMA FL1-2009 Standard. The tests are performed using the battery included in the flashlight.

Note: The maximum output brightness will decrease as the battery voltage decreases.

USB MAGNETIC CHARGING CABLE — MCC3

Parameter

|

Speci­cation

---|---
Charging cable| USB Type A – magnetic charging connector, length: 0.5m
Input| USB A – Type DC 5V 2A
Charging pattern| CC&CV
Maximum charging current| 2A
Full-capacity charging voltage| 4.2V±0.05V
Charge indication| Red: charging Green: full (over 95%) or disconnected with flashlight
Time to fully charge| 5.5 hours (For reference only. When the USB power source is insufficient to provide 5V 2A power capacity, the charging time will be longer)

PRODUCT OVERVIEW

BEFORE FIRST USE

Before first use, please remove the protective film on the lens; and please also unscrew the tailcap to remove the insulating film within the battery compartment, then screw the tailcap back on tightly. If the battery needs to be changed, make sure that the positive polarity side of the battery faces the flashlight head (the side of the LED).

CHARGING

Vibrating Power Indicator
It helps to alert if the battery is low (power<20% vibrate once every 5 minutes; power<10% vibrate once per minute; power<5% vibrate once every 10 seconds).

• Before first use please fully charge the product.
• Connect the USB Type-A end of the magnetic charging cable (MCC3) to an external USB power source, then attach the magnetic end to the magnetic charging port of the flashlight (best charging efficiency with a 10W (5V 2A) USB power source). The red indicator means charging, while the green indicator means charging completed (battery level＞95%).
• Only to charge with standard MCC3. NOT compatible with other MCC.

Tactical Grip Ring (TGR) Replacement Guide

1. Unscrew the tailcap and remove the O-ring
   

2. Then remove the metal TGR and pocket clip.
   

3. Install the silicone TGR and O-ring as shown in the picture and tighten the tailcap.
   

DANGER

• DO NOT throw the light directly into human eyes. This may cause temporary blindness, or permanent damage to the eyes.
• DO NOT cover the flashlight’s head or stand the flashlight on its head when it is on. The radiation energy may cause damage to the flashlight itself, or even result in the burning of flammable objects nearby.
• DO NOT use non-protected rechargeable batteries.

WARNING

• Keep out of reach of children.
• DO NOT activate high mode repeatedly under high temperature to prevent the flashlight body from overheating and hurting the user’s hand.
• The tail switch may not work while immersed in seawater or other conductive media. Please try to keep it clean and dry.
• If the product is left unused or carried and transported, please loosen the tailcap a half turn to avoid accidentally activating the flashlight.

NOTICE

• DO NOT throw the light directly into human eyes. This may cause temporary blindness, or permanent damage to the eyes.
• DO NOT cover the flashlight’s head or stand the flashlight on its head when it is on. The radiation energy may cause damage to the flashlight itself, or even result in the burning of flammable objects nearby.
• DO NOT use non-protected rechargeable batteries.
• DO NOT short-circuit the switch cap with the ring surrounding it. The short circuit in this case will result in an electric discharge of below 6mA between  them, and may lead to a complete battery drain if it is in this state for too long.

HOW TO OPERATE

Click the tail switch lightly to produce a low light output or press the tail switch hard to produce a high light output. Single click (click and release quickly) the tail switch to turn the flashlight on or off. When you press and hold the switch, the flashlight will be in momentary mode; when you release the tail switch, it will turn off.

WARRANTY

Within 30 days of purchase: Contact the original seller for repair or replacement.
Within 5 years of purchase: Contact Olight for repair or replacement.
Battery warranty: Olight offers a one year warranty for all rechargeable batteries. MCC magnetic USB charging cable: One year.

For any of the fragile or low-value fittings not covered above, like lanyard and clip, you can contact the post-sale in 30 days after the purchase, if it has any quality drawback or damage under normal use condition. If such drawback or damage occurs 30 days after the purchase or under abnormal use condition, we will only offer conditional quality assurance as appropriate.

USA Customer Support :  cs@olightstore.com
Global Customer Support :customer-service@olightworld.com
Visit www.olightworld.com to see our complete product line of portable illumination tools.

References

• Olight | Illuminate Your World.
• Flashlights, Tactical Light, Outdoor Tools - Olight Official Store- Olight

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>