John Lewis Ovals LED Wall Light User Manual
- June 7, 2024
- John Lewis
Table of Contents
John Lewis Ovals LED Wall Light User Manual
Thank you for purchasing this Ovals LED wall light. Please read the instructions carefully before use to ensure safe and satisfactory operation of this product.
Warnings!
This is a Class II product and must NOT be earthed. For your safety, this
product must be installed in accordance with local Building Regulations. If in
any doubt, or where required by the law, consult a competent person who is
registered with an electrical self-declaration scheme. Further information is
available online or from your Local Authority To prevent electric shock switch
off at mains supply before installing or maintaining this fitting. Ensure
other persons cannot restore the electrical supply without your knowledge.
This light fitting should be connected to a 5 amp fused circuit. This product
is suitable for installation on surfaces with normal flammability e.g. wood,
plasterboard, masonry. It is not suitable for use on highly flammable surfaces
(e.g. polystyrene, textiles). Ensure the correct fixings are used for the
installation surface. For your safety, always switch off the supply before
cleaning or adjusting. This product is not dimmable.
Parts list
Assembly
Refer to assembly drawing below. Carefully unpack the carton, making sure all the parts are present before assembly.
Step 1
Before removing the existing fitting, carefully note the position of each
set of wires.
Step 2
Refer to Figure. 1 Remove the fixing bracket (A) from the fitting by removing
side screws (B).
Step 3
Refer to Figure 2. Attach the fixing bracket to the wall using the screws
provided. Make care to avoid damaging any concealed wiring and pipes.
Step 4
Having identified the household wiring from your existing light fitting,
connect to the connection block inside the product as shown. When completed,
ensure that there are no bare or loose strands of wire exposed.
Check that
You have correctly identified the house wires. The connections are tight. No
loose strands have been left out of the connection block.
Step 5
Refer to Figure 3. Attach the product to the wall. This product has “L” shaped
fixing slots (C) to allow easy attachment to the fixing bracket. Locate the
“L” slots around the small screws (B) on the fixing bracket (A) Slide the wall
back to attach the product to the bracket. Tighten the screws to secure. Take
care not to trap any wiring.
Step 6
Replace fuse or circuit breaker and switch on. Your light is now ready for
use.
Care instructions
We recommend cleaning with a soft dry cloth. Do not use abrasive materials as these will damage the finish.
Recommended bulb
1 x 20 Watt energy efficient LED
This product contains a non-replaceable LED module. If the LEDs become damaged then the whole product must be replaced. When moving or cleaning, always switch off at the mains and allow the LEDs to cool before handling.
Specifications
Max. power: 20W
Voltage: 220-240V~50Hz
IP rating: IP20
Weight: 0.72kg
850 lumen output
Color temperature: Warm white (3000K)
Please retain these instructions for future reference.
This symbol indicates that this product should not be treated as normal household waste and it should be recycled. John Lewis do not operate instore take back, but as members of the Distributor Trade Back scheme have funded the development and upgrade of recycling facilities across the UK. Please take it to your nearest collection facility or for further details contact your local council or visit www.recycle-more.co.uk.
We have taken great care to ensure that this product reaches you in perfect condition. However, should any parts be damaged or missing please contact the Product Helpline on (01202) 690945.
John Lewis Partnership
171 Victoria Street
London SW1E 5NN
johnlewis.com
Made in China
References
- John Lewis & Partners | Department Store | Home, Fashion, Tech & More
- Everything you need to know to Recycle More
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>