JOHN LEWIS PARTNERS Ashbourne Floor Lamp User Guide

: June 5, 2024
: John Lewis Partners

Table of Contents

JOHN LEWIS PARTNERS Ashbourne Floor Lamp
Instruction
Product Assembly
Product information
Specification
5-year guarantee
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

JOHN LEWIS PARTNERS Ashbourne Floor Lamp

Instruction

Getting started

Thank you for purchasing this John Lewis & Partners product. For your safety, and to make sure everything is working properly, please read the instructions carefully before use.

Warnings

To prevent electric shock, switch off the mains supply before installing or maintaining this fitting. Ensure another person cannot restore the electricity supply without your knowledge. If you are in any doubt, please consult a qualified electrician. Always use the recommended bulb type and rated power. Never exceed the rated power stated. The flexible cable on this luminaire, if damaged, shall only be replaced by the manufacturer or his service agent or a similar qualified person. It is the installer’s responsibility to ensure that the fixings and plugs used are suitable for the surface you are fixing your product on. Caution! The bulb and surrounding parts can become hot during use. Do not cover. Keep away from curtains, bedding, etc. Always route the mains cable so it does not present a hazard (entrapment, tripping, etc.); Ensure that there are no twists or snags in the cable. Plug into the mains supply; switch on using the inline cord switch provided. When moving this lamp, always carry it by holding the standing part (and not the glass).

Product Assembly

Unpack the product (A) and remove all packaging.
Be careful not to scratch the surface of the product whilst removing the wrapping. Lay the product out on the floor. If the floor is not carpeted, please cover it with a soft cloth to avoid damage to the flooring and surface of the product. Assembly should take place with the product laying flat.
Attach the center pole to the lamp holder section by rotating it into place. Ensure the lamp holder section is kept still rotating only the center pole. Take care not to allow the electrical cable to twist.
Insert the pole assembly through the hole in the base section, pass the inline metal washer over the threaded section, and attach an inline nut to secure the pole to the base
Tighten the nut fully using the spanner tool provided
Gently pull any excess cable through the base.
Fit the shade (E) by first removing the shade ring already attached to the lamp holder section. Place the shade over the lamp holder and refit the shade ring to secure in place. Take care not to overtighten.
Stand the floor lamp upright and ensure all the assembled parts are fully tightened.
Fit the bulb: type and wattage as indicated on the fitting.
The wattage indicated must not be exceeded.
Your floor lamp is now ready to be plugged into the wall socket and is ready to use.

Product information

Indoor use only
Non-dimmable
Replacement bulbs should be the same type and rating, available from John Lewis
Partners or other established brands
Clean the fitting with a soft dry cloth

Aftercare and troubleshooting

If you experience any unresolvable technical issues with the product, contact your nearest John Lewis & Partners shop or
John Lewis & Partner Technical Support on 03301 230106.
Why is the light not working when switched on?
Check your power supply is switched on
Turn off the light and check that the bulb is inserted correctly
Check the bulb is still in working order.

Specification

Recommended bulb: ES GLS LED bulb
Rated input: 220 –240V, 50Hz
Max power: 10W LED
Bulb not included
IP rating: 20
Weight: 2.7Kg

5-year guarantee

At John Lewis & Partners we test every light to high-quality standards so we are able to offer you a 5-year guarantee.

Recycling

This symbol indicates that this product should not be treated as normal household waste and it should be recycled. John Lewis & Partners do not operate instore take back, but as members of the Distributor Take Back scheme have funded the development and upgrade of recycling facilities across the UK. Please take it to your nearest collection facility or for further details contact your local council or visit www.recycle-more.co.uk.