HOLLYLAND MARS 300 Pro Standard Single Transmitter User Manual
- June 7, 2024
- HOLLYLAND
Table of Contents
HOLLYLAND MARS 300 Pro Standard Single Transmitter
KEY FEATURES
- Wheel Button on the Side, One-button Rolling Adjustment
- OLED Screen Display on the Side
- 300ft Transmission Range between TX and APP (LOS)
- Transmission Latency is 0.1s
- HDMI Input & HDMI Loop out at TX
- Supports USB Type-C Power Supply
- 1 Transmitter Supports up to 3 APPs Monitoring
- Supports Smart Channel Selection
- Supports APP Firmware Upgrade
PACKING LIST
- Transmitter x1
- User Guide x1
- Expansion Accessory x1
- Cold Shoe x1
- USB Type-A to Type-C data cable x1
TYPICAL SETUP
PRODUCT INTERFACES
- Built-in Antenna
- OLED Screen
- Wheel Button
- Power Switch
- Mounting Hole of the Expansion Accessory
- HDMI Loop out
- HDMI Input
- USB Type-C Interface
- 1/4 Screw Hole
INSTALLATION
-
Install the transmitter as demonstrated.
-
Vertical Installation: Secure the cold shoe with 1/4 screw hole at the bottom of the transmitter and mount it to the camera.
Horizontal Installation: Connect the expansion accessary to the transmitter’s mounting hole and secure the cold shoe with hole at the expansion accessary. Then install them on the camera. -
Connect the HDMI input of the transmitter with camera’s by HDMI cable.
-
Connect to a power supply (Compatible with NP-F970 or the same series of batteries).
-
Turn on the device.
OLED DISPLAY
- Device ID
- WiFi Signal Strength
- Fan Status Display
- Battery Voltage Display
- Channel Display
- Video Format
QUICK GUIDE
ENTER MENU
Long press the wheel button for about 3 seconds to enter the root menu
interface.
Push up or down the wheel button to switch the menu page, press down the wheel
button to confirm.
CHANNEL CHANGE
Push up or down the wheel button to change the channel at transmitter. Press
down the wheel button to confirm the channel.
IOS System and Android System Installation and Connection
- “HollyView” APP Download
- Enter the WiFi connection interface of the phone. Find the device’s WiFi (WiFi names as “HLD+Device ID” ). Input WiFi password to connect (Factory default password: 12345678). After the WiFi connection is successful, enter the APP to monitor the screen.
PARAMETERS
| Transmitter | |
|---|---|
| Interface | HDMI Input (Type A Female) HDMI Loop out (Type A Female) USB |
Type-C
Supply Interface| USB Type-C Supply: 5V/2A Battery Supply: 5-12V DC
Power Consumption| < 11W
Weight| 136g
Deminsion| (LWH): 1106121mm The battery plate excluded
Input / Output Video Format| HDMI: 480p60
576p50
720p50/59.94/60
1080i50/59.94/60
1080p23.98/24/25/29.9/30
1080p50/59.94/60
Frequency| 5GHz
Modulation Mode| OFDM
Transmission Power| Maximum 21dBm
Transmission Latency| 0.1s
Bandwidth| 20MHz
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>