VAULT AI-PRO-IP Mounting Component For Tablet Instruction Manual
- June 13, 2024
- VAULT
Table of Contents
VAULT AI-PRO-IP Mounting Component For Tablet
Models
-
11″ Enclosure
-
12.9″ Enclosure
PARTS INCLUDED
-
Faceplate
(1) -
Backplate
(1) -
Rubber Spacer
(6)
PRO-IP11 ENCLOSURE HARDWARE PACK
-
10-32×1/2
Flat Head
(4) -
6-32×1/2
Flat Head
(2)
PRO-IP12 ENCLOSURE HARDWARE PACK
- 10-32×1/2
Flat Head
(6)
PREASSEMBLY
Insert rubber spacer into specified locations.
- 12.9″ iPad Pro
- 11″ iPad Pro – Place In location 2
- 10.9″ iPad Air- Place in location 2
- 10.9″ iPad (10th Gen) – Place in location 2
- 10.5″ i Pad Pro – Place In location 2
- 10.2″ iPad (9th Gen)- Place in location l
If REPEL is installed on 10.2″ iPad don’t use spacers.
Route cabling through access holes in the back plate.
-
PLACE TABLET INTO FACE PLATE
Ensure that PREASSEMBLY steps have been followed concerning the rubber spacers. -
PLACE BACKPLATE OVER THE FACEPLATE AND INSERT SCREWS
Refer to base mounting instructions before proceeding with this step if you are using a VESA mounted base.
REFER TO CREDIT CARD BRACKET INSTRUCTIONS
TO FINISH YOUR SOLUTIONS ASSEMBLY (OPTIONAL)
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>