FEIT Area Light Instruction Manual
- June 7, 2024
- Feit
Table of Contents
FEIT Area Light Instruction Manual
PARTS INCLUDED
(1) Area light
(3) Mounting screws
(3) Screw anchors
(3) Wire nuts
CAUTION, IMPORTANT SAFETY INSTRUCTIONS
Make sure the supply voltage is the same as the rated luminaire voltage. Do
not install where marked operating temperatures exceed the ignition
temperature of the hazardous atmosphere. Do not operate in ambient
temperatures above those indicated on the luminaire nameplate. To avoid the
risk of fire, explosion, or electric shock, this product should be installed,
inspected and maintained by a qualified electrician only, in accordance with
all applicable electrical codes. Be certain electrical power is OFF before and
during installation and maintenance.
Note : Save these instructions for future reference.
For supply connections use wire rated for at least 90°C
CAUTION : Input 120 VAC
LIMITED WARRANTY
This product is warranted to be free from defects in workmanship and materials
for up to 5 years from date of purchase. If it fails to do so, please contact
Feit Electric at [email protected] or call 1-866 326-BULB
(2852)
for instructions on replacement. Do not return the product to the store.
For comments please write to :Feit Electric Customer Service Department 4901
Gregg Road , Pico Rivera, CA 90660
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio Any changes or modifications not expressly approved by the manufacture could void the user’s authority to operate the equipment. Frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help.
FEIT ELECTRIC COMPANY I PICO RIVERA, CA| 800-543-3348 I FAX 562-908-6360 | www.feit.com
WARNING: TU RN OFF THE MAIN POWER AT THE Cl RCU IT BREAKER BEFORE
INSTALLING THE FIXTURE IN ORDER TO PREVENT POSSIBLE ELECTRIC SHOCK.
Pole Mount Installation
Wall Mount Installation
FEIT ELECTRIC COMPANY I PICO RIVERA , CA | 800-543-3348 I FAX 562-908-6360 | www.feit.com