iPGARD SA-DPN-4S 4 Port DP Secure KVM Switch User Guide
- June 3, 2024
- iPGARD
Table of Contents
iPGARD SA-DPN-4S 4 Port DP Secure KVM Switch
WHAT’S IN THE BOX
NOTICE
The information contained in this document is subject to change without
notice. regard makes no warranty of any kind with regard to this material,
including but not limited to, implied warranties of merchantability and
fitness for a particular purpose. iPGARD will not be liable for errors
contained herein, or for incidental or consequential damages in connection
with the furnishing, performance, or use of this material. No part of this
document may be photocopied, reproduced, or translated into another language
without prior written consent from iPGARD, Inc. 20170518
TECHNICAL SPECIFICATIONS
A full manual can be downloaded from www.ipgard.com/documentation/
EDIT LEARN
The KVM switch is designed to learn a connected monitor’s EDID upon power up. In the event of connecting a new monitor to the KVM a power recycle is required. The KVM switch will indicate the unit’s EDID learning process is active by flashing the front panel’s LEDs in sequential order. Starting with the LED above button “1” on the front panel, each LED will flash green for approximately 10 seconds upon beginning the EDID learn. Once all the LEDs stop flashing, the LEDs will cycle and the EDID learn will be complete. If the KVM switch has more than one video board (such as dual-head and quad-head models), then the unit will continue to learn the EDIDs of the connected monitors and indicate the progress of the process by flashing the next port selection green and blue push-button LEDs respectively. A monitor must be connected to the video output port located in the console space at the back of the KVM switch during the EDID learn the process. If the read EDID from the connected monitor is identical to the current stored EDID in the KVM switch, then the EDID learn function will be skipped.
HARDWARE INSTALLATION
- e that power is turned off or disconnected from the unit and the computers.
- Use DisplayPort cables to connect the DisplayPort output ports from each computer to the corresponding DP IN ports of the unit.
- Use a USB cable (Type-A to Type-B) to connect a USB port on each computer to the respective USB ports of the unit.
- Optionally, connect a stereo audio cable (3.5 mm to 3.5 mm) to connect the audio output of the computer(s) to the audio in ports of the unit.
- Connect monitor(s) to the DP OUT console port of the unit using DisplayPort cable(s)
- Connect a USB keyboard and mouse in the two USB console ports.
- Optionally, connect stereo speakers to the audio out port of the unit.
Note
You can connect one monitor to the single-head KVM switch. The computer
connected to port 1 will always be selected by default after powering up.
Note: You can connect up to 4 computers to the 4 port KVM.
A full Manual can be downloaded from www.ipgard.com/documentation/
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>