Setup Dimmer Switch with Home Assistant Print
- June 7, 2024
- Aeotec
Table of Contents
Connecting illumino Dimmer Switch to Home Assistant requires a working installation of that software with Z-Wave management being handled by Aeotec’s Z-Stick platform. Once connected to Z-Stick and Home Assistant with Z-WaveJS to MQTT, illumino Dimmer Switch will offer the following features for either product:
- On/off switch
- Dimmer
- Scene controller
Steps to connect illumino Dimmer Switch to Home Assistant.
- Open Home Assistant Interface: http://homeassistant:8123/
- Click on “ Configuration ” at the bottom left of the page.
- Click on “ Integrations “.
- Click on “ Configure ” under your Z-Wave JS integration.
- Click on “ ADD NODE “.
- Click on “ START INCLUSION “.
- Now tap the top or bottom Button on illumino Dimmer Switch.
- Allow about 1-2 minutes to allow your Home Assistant to scan the device information and populate the correct device information about it.
How to remove or factory reset your illumino Dimmer Switch **from Home Assistant.**
- Open Home Assistant Interface: http://homeassistant:8123/.
- Click on “ Configuration ” at the bottom left of the page.
- Click on “ Integrations “.
- Click on “ Configure ” under your Z-Wave JS integration.
- Click on “ REMOVE NODE “.
- Click on “ START EXCLUSION ” – Your Home Assistant should start scanning for device button presses.
- Now tap the top or bottom Button 3x times in 2 second on illumino Dimmer Switch.
- Home Assistant will stop scanning for devices excluded (if not paired), if a device is paired, it will state which device it was removed. Reload the page, and you should notice one less device node under “Nodes ready” if it was connected previously.
Troubleshooting
Having issues pairing your device?
-
Move your Sensor within 4 – 10 ft of your Home Assistant Z-Wave network.
-
Remove power from illumino Dimmer Switch for 1 minute, then power it up again.
-
Try factory resetting or excluding your illumino Wall Switch.
- Exclude first in case the device actually paired to Home Assistant otherwise it will leave a phantom device in your network that will be difficult to remove.
- Perform a manual hard factory reset.
- Press and hold the Action Button for 20 seconds until the blue LED becomes solid at 20 seconds.
- Immediately release, and tap the button once again.
- If successful, the LED will fade blue in/out to indicate that it is ready to be connected to another hub.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>