Setup Door/Window Sensor 7 with Hubitat Print

This guide will leave you through connecting your Door / Window Sensor 7 with Hubitat which will feature these functions for either ZWA011 or ZWA012:

Door / Window Sensor 7 Gen7 (ZWA011)

• Open/Close status
• Tamper
• Battery level

Door / Window Sensor 7 Pro Gen7 (ZWA012)

• Open/Close status
• Sensor Operation Mode configuration
  • Internal Magnet Sensor
  • External Terminal Inputs
• Tamper
• Battery level

Steps to pair Door/Window Sensor 7 to Hubitat.

1. Open your Hubitat interface.
2. Click on Devices.
3. Click on Discover Devices.
4. Click on Z-Wave.
5. Click on Start Z-Wave Inclusion.
6. Remove the cover of your Door/Window Sensor 7.

7. Now tap the small black tamper switch 3x quickly on Door/Window Sensor 7.

8. A device box should appear almost immediately, give it about 20 seconds to initialize, feel free to name your device and save this.
9. Now go to “ Devices “.
10. Click on your Door/Window Sensor 7.
11. Under “ Device Information ” change Type to “ Aeotec Door/Window Sensor 7 Series “.
12. Click on “ Save Device “.

How to exclude Door/Window Sensor 7 from Hubitat.

1. Open your Hubitat interface.
2. Click on Devices.
3. Click on Discover Devices.
4. Click on Z-Wave.
5. Click on Start Z-Wave Exclusion.
6. Remove the cover of your Door/Window Sensor 7.

7. Now tap the small black tamper switch 3x quickly on Door/Window Sensor 7.

8. Your Hubitat should tell you if it excluded an unknown device or a specific sensor if it was paired properly previously.

Troubleshooting

Having issues pairing your device?

• Move your Sensor within 4 – 10 ft of your Hubitat Z-Wave network.

• Remove power from Door/Window Sensor 7 for 1 minute, then power it up again.

• Try factory resetting or excluding your Door/Window Sensor 7.

  • Exclude first in case the device actually paired to Hubitat otherwise it will leave a phantom device in your network that will be difficult to remove.
  • Perform a manual hard factory reset
  1. Remove the cover of your Door/Window Sensor 7
  2. Press and hold the tamper switch for 5 seconds until the red LED blinks.
  3. Quickly release the tamper switch , and then immediately press and hold again. 

  * If successful, the LED will display a solid green LED.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>