NUU GARDEN SCD004-01 3PCS Cast Aluminum Bistro Set Instruction Manual
- June 6, 2024
- NUU GARDEN
Table of Contents
C3PCS Cast Aluminum Bistro Set
SKU: SCD004-01
INSTRUCTION MANUAL
INTRODUCTION
Thanks for purchasing and trusting NUUGARDEN with your home decorating plans.
This product is furniture designed and made by NUUGARDEN Corp.
We are committed to R&D innovation and to creating the most refined, diverse
choice of outdoor collection.
After unpacking and before every use, check whether the item shows any
damages. In addition, check that you have all parts and hardware before
assembly. If there is any damage, please do not use it and just call customer
service at 800-257-7108 or send an
email to service@nuugarden.com.If you do not
have all the parts lists, have your dealer contacts us and they will be sent
to you immediately.
This furniture is intended for indoor and outdoor use. Please take time to
read and follow the instruction below. Use the item as described in this
operating manual. We accept no liability for damages caused by improper use.
ASSEMBLY INSTRUCTIONS
Step 1: Attach the front and back Legs (C, D) to the studs on the chair
seat (B) using washers and nuts (L, M, N). Do not tighten the nuts.
Step2: Attach the backrest (A) to the chair seat (B) using washers and nuts
(L, M, N). Do not overtighten.
Step3: Attach the right and left arm(E, F) using the bolts (K) and washers and
nuts (H, I, J). Do not overtighten.
Step4: Attach the right and left arm(E, F) using the bolts (G) and washers,
nuts (H, I, J). Do not overtighten.
Step5: Upon completion of full assembly and bolted up-all screws can be
tightened down. Add the protect hats (O, P).
Note: Please do not tighten any bolt until all bolts have been put in the
right place.
If you tighten one bolt, it may be causes other bolts out of position.
ASSEMBLY INSTRUCTIONS
Step1: Attach the 3 legs (C) to the tabletop (A) using bolts (D), washers, and
nuts (E, F, G). Do not overtighten.
Step2: Attach the 3 legs (C) to the legs support (B) using bolts(H), washers,
and nuts (I, J, K). Do not overtighten.
Step3: Upon completion of full assembly and bolted up-all screws can be
tightened down. Add the protect hats (L, M).
Note: Please do not tighten any bolt until all bolts have been put in the
right place.
If you tighten one bolt, it may be because other bolts are out of position.
CARE AND MAINTENANCE
Follow the instruction for the material of your special product to make sure that it stays in the best shape for as long as possible. The information below is only intended as a general guideline. For more information, please contact us.
-
Only need to rinse it thoroughly with clean water to wash away dirt and grime. Never use abrasive cleaners on the furniture, since they can attack the surfaces and leave behind scratch marks.
-
For the stubborn grime and stains, just use a soft sponge and mild soapy water and then dry it with a cloth or paper towel.
-
Check the stability of the screws, nuts, and nut caps prior to each use.
Tighten up them after one to two months’ use whenever required. -
Avoid improper use, and be careful not to scratch or damage the surface with sharp objects.
-
When you move your furniture, make sure you lift it rather than pulling or pushing it to avoid damaging the floor, legs, and mounting.
CUSTOMER SERVICE
Thanks for purchasing this NUUGARDEN furniture. We are here to help you
maximize your enjoyment and appreciation of it.
Please do not hesitate to contact our customer service when you have any
questions regarding assembly or accessories.
Add 6366 Corley Road, Norcross, GA 30071.
Tel: 800-257-7108
Web:http://www.nuugarden.com
E-mail: service@nuugarden.com
Service time: Mon-Fri, 8:30 AM-5:30 PM, EST
References
- Online Garden Centre | Garden Plants
- Nuu Garden Outdoor Living | Garden Furniture & BBQ & Fire Pit | Nuu Garden
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>