NISBETS CT956-A Electric Fryer Instruction Manual

: June 7, 2024
: NISBETS

NISBETS CT956-A Electric Fryer

Product

Safety Tips

Position on a flat, stable surface.
A service agent/qualified technician should carry out installation and any repairs if required. Do not remove any components on this product.
Consult Local and National Standards to comply with the following:
- Health and Safety at Work Legislation
- Fire Precautions
- Wiring Regulations
- Building Regulations
Caution! Hot surface!
DO NOT immerse the appliance in water.
DO NOT clean with jet/pressure washers.
DO NOT move or carry the appliance when it is switched on.
DO NOT leave the appliance unattended during operation.
Caution! Never switch on the deep fryer without oil inside.
ALWAYS ensure oil levels are within the ‘MIN’ and ‘MAX’ levels. Failure to do so could result in fire.
ALWAYS use a suitable cooking oil.
ALWAYS remove excess moisture/water from food before frying to avoid excess foaming and spitting of the oil.
Change oil regularly. The flashpoint of oil (the point at which it ignites) gradually reduces the more it is used.
In case of fire, never use water to extinguish it.
Never pour water onto hot oil or fat. Use the lid to cover the fire instead.
During and after cooking, the unit is still hot. Never touch the surface to avoid scalding.
Suitable for indoor use only.
Always switch off and disconnect the power supply to the appliance when not in use.
This appliance must only be used in accordance with these instructions and by persons competent to do so.
Keep all packaging away from children. Dispose of the packaging in accordance to the regulations of local authorities.
If the power cord is damaged, it must be replaced by a Nisbets Essentials agent or a recommended qualified technician in order to avoid a hazard.
This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience or knowledge, unless they have been given supervision or instruction concerning the use of the appliance by a person responsible for their safety.
Children should be supervised to ensure that they do not play with the appliance.
Nisbets Essentials recommend that this appliance should be periodically tested (at least annually) by a Competent Person. Testing should include, but not be limited to: Visual Inspection, Polarity Test, Earth Continuity, Insulation Continuity and Functional Testing.

Introduction

Please take a few moments to carefully read through this manual. Correct maintenance and operation of this machine will provide the best possible performance from your Nisbets Essentials product.
This appliance is intended to be used for commercial applications, for example in kitchens of restaurants, canteens, hospitals and in commercial enterprises such as bakeries, butcheries, etc. but not for continuous mass production of food.

Pack Contents

The following is included:

5Ltr Single Tank Single Basket Fryer – 2.2kW
Lid
Frying basket
Batter plate
Instruction manual

Nisbets Essentials prides itself on quality and service, ensuring that at the time of packaging the contents are supplied fully functional and free of damage. Should you find any damage as a result of transit, please contact your Nisbets Essentials dealer immediately.

Installation

Place the unit on a heat-resistant surface. Avoid placing it on or close to flammable materials. Maintain a distance of 20cm (7 inches) between the appliance and walls or other objects for ventilation.
Keep the unit away from splashing water and counter-top’s edge.

Operation

Control Panel

Assembly

Place the oil tank into the tank holder.
Place the control unit onto the tank holder, making sure the studs of the control unit rest stably on the support bracket of the tank holder.
Place the batter plate into the oil tank.
Attach the basket handle to the frying basket as described below:
- Press the wire bars together. Insert the 2 ends of the wires into the bracket loops of the frying basket.
- Press the basket handle on the clip of the basket until it locks into place.
- Now the basket handle is locked in place.

Start Frying

Pour cooking oil into the oil tank between the MIN and MAX markings.
Connect the appliance to the mains power supply.
Set the POWER switch to I ( ON position). The POWER indicator light (green) illuminates.
Set the thermostat to the desired temperature. The HEAT indicator light (orange) turns On. The appliance begins to heat the oil.
- Note: 170°C to 180°C is suitable for general cooking.
When the set temperature is reached, the HEAT indicator light turns Off.
Lower the basket with food into the oil. The HEAT indicator light turns On again.
- Note: During use, the HEAT indicator light will cycle on/off, indicating the set temperature is being maintained.
When the food is cooked, lift the basket and hang it onto the control unit’s rod. Allow the oil to drain from the frying basket for seconds.
After use, set the POWER switch to O ( OFF position) and disconnect the appliance from power supply.

Overheat Protection

This appliance is featured with an overheat protection. Should the temperature exceed safe levels the appliance will automatically cut off power. The thermal Cut-out switch is located on the front of the control unit. To reset the appliance after a sufficient cool-down period:

Unscrew the reset switch cover.
Press the small reset switch down until it clicks, using a blunt pointed instrument.
The appliance is now reset and can be used as normal.

Cleaning, Care & Maintenance

Check the temperature with a suitable probe thermometer; 40ºC is the MAXIMUM temperature at which oil should be removed.
For best performance, Nisbets Essentials recommend that the appliance is cleaned after each day of operation.
Note: Failure to clean the appliance regularly may result in premature activation of the thermal cut-out switch.

Empty the Oil Tank

Ensure to remove the frying basket first.
Slowly rotate the control unit backward 90º until it is locked vertically on the support brackets of the tank holder. During this period, ensure to hold the batter plate carefully.
Let the oil accumulated on the batter plate and heating elements recycle into the oil tank.
Remove the batter plate, control unit and oil tank consecutively.
If the remaining oil is to be reused, then filtering it before refilling will extend the oil’s cooking life.

Clean all Removable Parts

Use warm, soapy water and a soft brush to clean the lid, basket, batter plate and oil tank.
Dry thoroughly.
A Nisbets Essentials dealer or qualified technician should carry out repairs if required.

Troubleshooting

If your Nisbets Essentials appliance develops a fault, please check the following table before making a call to the Helpline.

Fault

|

Probable Cause

|

Solution

---|---|---
The unit is not working| The unit is not switched on| Check the unit is plugged in correctly and switched on
Plug and lead are damaged| Call Nisbets Essentials agent or qualified technician
Fuse in the plug has blown| Replace the plug fuse
Power supply| Check power supply
Internal wiring fault| Call Nisbets Essentials agent or qualified technician
Oil spilling over| Too much food in the frying basket| Remove some food
Food is not dry| Dry food before frying
Unit slow to heat up| Build-up of fat in the tank| Clean the appliance
Unit stops working suddenly| Overheat protection is activated| Allow to cool. Then press the RESET switch

Technical Specifications

Model

|

Voltage

|

Power

|

Current

|

Capacity

|

Dimensions
h x w x d (mm)

|

Weight

---|---|---|---|---|---|---
CT956-A| 220-240V~ 50/60Hz| 2200W| 9.5A| 5 Liters| 270 x 290 x 430| 6kg

Electrical Wiring

The plug is to be connected to a suitable mains socket. This appliance is wired as follows:

Live wire (colored brown) to terminal marked L
Neutral wire (colored blue) to terminal marked N
Earth wire (colored green/yellow) to terminal marked E

This appliance must be earthed. If in doubt consult a qualified electrician.

Electrical isolation points must be kept clear of any obstructions. In the event of any emergency disconnection being required they must be readily accessible.

Compliance

The product must not be disposed of as household waste. To help prevent possible harm to human health and/or the environment, the product must be disposed of in an approved and environmentally safe recycling process. For further information on how to dispose of this product correctly, contact the product supplier, or the local authority responsible for waste disposal in your area.