NISBETS FD499 Fly Killer 16W User Manual
- June 6, 2024
- NISBETS
Table of Contents
Fly Killer
Instruction manual
Model
FD499
Safety Tips
-
A service agent/qualified technician should carry out installation and any repairs if required. Do not remove any components on this product.
-
Consult Local and National Standards to comply with the following:
– Health and Safety at Work Legislation
– BS EN Codes of Practice
– Fire Precautions
– IEE Wiring Regulations
– Building Regulations -
Always switch off and disconnect the power supply to the appliance before cleaning.
-
Install the appliance out of the reach of children.
-
Never insert hands or other objects into the appliance while it is connected to the power supply.
-
Install the Fly Killer at least 1 meter away from food preparation areas.
-
Never use near flammable objects.
-
For INDOOR use only.
-
Keep all packaging away from children. Dispose of the packaging in accordance with the regulations of local authorities.
-
If the power cord is damaged, it must be replaced by an Nisbets Essentials agent or a recommended qualified technician in order to avoid a hazard.
-
Nisbets Essentials recommends that this appliance should be periodically tested (at least annually) by a Competent Person. Testing should include, but not be limited to Visual Inspection, Polarity Test, Earth Continuity, Insulation Continuity, and Functional Testing.
-
Danger – High voltage!
-
The appliance emits UV radiation. Do not stare at the light.
-
The appliance is not to be used in locations where flammable vapor or explosive dust is likely to exist.
-
Do not use in barns, stables, and similar locations.
-
Nisbets Essentials recommend that this product be connected to a circuit protected by an appropriate RCD (Residual Current Device).
Introduction
Please take a few moments to carefully read through this manual. Correct maintenance and operation of this machine will provide the best possible performance from your Nisbets Essentials product.
Pack Contents
The following is included:
- Fly Killer
- Instruction manual
- Hanging chain
Nisbets Essentials prides itself on quality and service, ensuring that at the
time of packaging the contents are supplied fully functional and free of
damage.
Should you find any damage as a result of transit, please contact your Nisbets
Essentials dealer immediately.
Installation
Note: Ensure the mounting substrate and the fixings used can support the weight of the appliance. If in doubt seek professional advice or assistance.
- Remove all packaging and protective film from the Fly Killer.
| Note: Close proximity to other light sources such as skylights and windows will reduce the effectiveness of the Fly Killer.
---|--- - For best results, locate the Fly Killer in the darkest part of the room, but at least 1 meter away from food preparation areas.
- Connect the appliance to mains power.
Operation
|
WARNING: Under no circumstances should hands be placed anywhere near the high voltage grid when the appliance is operational.
---|---
The fly killer works by luring insects onto an electrified metal grid using
ultra-violet light. It uses no chemicals and is pollution-free. To use the Fly
Killer:
- Press the switch to the ON (I) position. Ensure it is set to OFF (O) before plugging into mains.
- The light will come on and the grid will become electrically charged.
Cleaning, Care & Maintenance
| Always switch off the power and disconnect the appliance from the power
supply before cleaning.
---|---
- Clean the collection tray regularly with warm soapy water.
- DO NOT immerse the appliance in water. Wipe the safety guard and external casing with a damp cloth.
- Change the bulbs every 9 months.
Changing the Bulb
|
WARNING: Always turn Off the appliance and disconnect from the power supply
before changing the
bulb.
---|---
-
Remove the collection tray.
-
Lay the appliance face down.
-
Unscrew the two screws holding the safety guard at the rear of the Fly Killer [Fig. 1].
-
Lift up the guard rail [Fig. 2].
-
Holding the ends of the bulb, twist it ‘forwards’ in its socket until it clicks [Fig. 3].
-
Slide the bulb up out of its sockets [Fig. 4].
-
Replace with a new bulb.
-
Twist the new bulb ‘backward to lock it back in place.
-
Replace the guard rail and the two screws.
Troubleshooting
Fault| Probable Cause|
Solution
---|---|---
The appliance is not working| The unit is not switched on| Check the unit is
plugged in correctly and switched on
Plug and lead are damaged| Call Nisbets Essentials agent or qualified
Technician
Fuse in the plug has blown| Replace the plug fuse
Power supply| Check power supply
Internal wiring fault| Call Nisbets Essentials agent or qualified technician
Tube has expired| Refer to the ‘Changing the Bulb’ section
Tube is faulty or has not been fitted correctly
Technical Specifications
Model
| Voltage| Power| Dimensions
h x w x d (mm)|
Weight
---|---|---|---|---
FD499
| 220-240V-, 50Hz| 23W| 272 x 350 x 86|
2.56kg
Electrical Wiring
This appliance is supplied with a 3 pin BS1363 plug and lead.
The plug is to be connected to a suitable mains socket.
This appliance is wired as follows:
- Live wire (colored brown) to the terminal marked L
- Neutral wire (colored blue) to the terminal marked N
- Earth wire (colored green/yellow) to terminal marked E
| This appliance must be earthed.
If in doubt consult a qualified electrician.
---|---
Electrical isolation points must be kept clear of any obstructions. In the event of any emergency disconnection being required, they must be readily accessible.
Compliance
|
The WEEE logo on this product or its documentation indicates that the product must not be disposed of as household waste. To help prevent possible harm to human health and/ or the environment, the product must be disposed of in an approved and environmentally safe recycling process. For further information on how to dispose of this product correctly, contact the product supplier, or the local authority responsible for waste disposal in your area.
---|---
|
Nisbets Essentials parts have undergone strict product testing in order to
comply with regulatory standards and specifications set by international,
independent, and federal authorities.
Nisbets Essentials products have been approved to carry the following symbol:
---|---
All rights reserved. No part of these instructions may be produced or
transmitted in any form or by any means, electronic, mechanical, photocopying,
recording, or otherwise, without the prior written permission of Nisbets
Essentials.
Every effort is made to ensure all details are correct at the time of going
to press, however, Nisbets Essentials reserves the right to change
specifications without notice.
DECLARATION OF CONFORMITY
- Conformiteitsverklaring
Equipment Type
|
Model
---|---
Flykiller
|
FD499 (& -E -A)
Application of Territory Legislation & Council Directives(s)
Toepassing van Europese
Richtlijn| Low Voltage Directive (LVD) – 2014/35/EU EN 60335-1:2012
+A11:2014
EN 60335-2-59:2003 +A1:2006 +A2:2009 EN
62233:2008
Electro-Magnetic Compatibility (EMC)
Directive 2014/30/EU – recast of 2004/108/EC EN55014-1:2017
EN 55014-2:2015 EN 61000-3-3:2013 EN 61000-3-2:2014
Restriction of Hazardous Substances Directive (RoHS) 2015/863 amending
Annex II to Directive 2011/65/EU| Electrical Safety
EN 60335-1:2012 +A11:2014
EN 60335-2-59:2003 +A1:2006 +A2:2009 EN 62233:2008
Electromagnetic Compatibility
EN 55014-1:2017 EN 55014-2:2015 EN 61000-3-2: 2014 EN 61000-3-3: 2013
Producer Name| Nisbets Essentials
I, the undersigned, hereby declare that the equipment specified above
conforms to the above Territory Legislation, Directive(s) and Standard(s).
Date
Signature • Handtekening • Signature • Unterschrift Firma • Firma • Assinatura
Full Name
Position
Producer Address
4th December 2020
Ashley Hooper| Eoghan Donnellan| Josie Holt
Technical & Quality
Manager| Commercial
Manager/ Importer| Commercial Manager/ Responsible
Supplier
Fourth Way, Avonmouth,Bristol,
BS11 8TB
United Kingdom| 42 North Point
Business Park New Mallow Road
Cork Ireland| 15 Bagdally Road, Campbelltown
NSW 2560
| UK | +44 (0)845 146 2887 |
|---|
Eire
NL| 040 — 2628080
FR| 01 60 34 28 80
BE-NL| 0800-29129
BE-FR| 0800-29229
DE| 0800 — 1860806
IT| N/A
ES| 901-100 133
PT| vendasOnisbets.pt
FD499_ML_A5_v1_20201217
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>