Tom Raffield Loer Pendant Installation Guide
- June 7, 2024
- Tom Raffield
Table of Contents
**Tom Raffield Loer Pendant Installation Guide
**
Installation Instruction
Only qualified persons should assemble the luminaire. If in doubt, consult a
suitably qualified electrician.
Installation MUST be carried out in accordance and compliance with current
building regulations.
Ensure the electrical supply is turned OFF at the fuse board.
The Loer Pendant has been designed to fit the E27/ES (Edison Screw) fitting
ceiling kit provided. After adjusting the flex length to suit your space if
needed, connect the ceiling rose (A) to the electricity supply (220-240V AC
50-60Hz). This must be installed by a qualified electrician before following
the
instructions below. The Loer pendant should be connected to the electricity
supply and fixed to the ceiling before fitting the bulb and glass sphere
diffuser due to the fragility of the glass.
Once the ceiling kit has been connected to the electricity supply and the pendant securely attached to the ceiling, screw in the light bulb supplied (A). The lampshade has been designed to work with an LED bulb, up to a maximum of 9.5 Watts.
- Carefully thread glass sphere over the light bulb (B) and locate onto the brass thread of the bulb holder. Gently tighten the sphere onto the bulb holder securely connecting the two parts. Due to the fragility of the glass sphere diffuser, this step should be carried out with great care to avoid breakage.
- Turn the power supply on to complete installation.
- If the external flexible cable or cord of this luminaire is damaged, it shall be exclusively replaced by the manufacturer or his service agent or a similar qualified person in order to avoid a hazard.
- For indoor use only.
Contact Us
For more information on the installation of your product:
web : contact@tomraffield.com
Phone: +44 (0)1326 722725
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>