milwaukee REDLITHIUM USB HARD HAT HEADLAMP Instructions
- June 7, 2024
- Milwaukee
Table of Contents
milwaukee REDLITHIUM USB HARD HAT HEADLAMP Instructions
IMPORTANT SAFETY INSTRUCTIONS
WARNING READ AND UNDERSTAND ALL INSTRUCTIONS. Failure to
follow all instructions listed below, may result in electric shock, fire
and/or serious personal injury.
SAVE THESE INSTRUCTIONS
- SAVE THESE INSTRUCTIONS – THIS MANUAL CONTAINS IMPORTANT SAFETY AND OPERATING INSTRUCTIONS FOR REDLITHIUMTM USB BATTERIES AND THE REDLITHIUMTM USB HARD HAT HEADLAMP.
- USE AND CHARGE ONLY REDLITHIUMTM USB BATTERIES IN THIS USB RECHARGEABLE LIGHT. OTHER TYPES OF BATTERIES MAY CAUSE PERSONAL INJURY AND DAMAGE.
- BEFORE USING THE BATTERY AND LIGHT, READ THIS OPERATOR’S MANUAL AND ALL LABELS ON THE BATTERY AND LIGHT.
- AVOID DANGEROUS ENVIRONMENTS. Do not charge battery in rain, snow, damp or wet locations. Do not use battery or charger in the presence of explosive atmospheres (gaseous fumes, dust or flammable materials) because sparks may be generated when inserting or removing battery, possibly causing fire.
- CHARGE IN A WELL VENTILATED AREA. Do not allow smoking or open flames near a charging battery. Vented gases may explode.
- USE ONLY RECOMMENDED ATTACHMENTS. Use of an attachment not recommended or sold by the battery charger or battery manufacturer may result in a risk of fire, electric shock or personal injury.
- TO REDUCE THE RISK OF ELECTRIC SHOCK, always unplug charger before cleaning or maintenance.
- DO NOT BURN OR INCINERATE BATTERY PACKS. Battery may explode, causing personal injury or damage. Toxic fumes and materials are created when battery are burned.
- DO NOT CRUSH, DROP, OR DAMAGE battery. Do not use a battery or charger that has received a sharp blow, been dropped, run over, or damaged in any way (e.g., pierced with a nail, hit with a hammer, stepped on).
- DO NOT DISASSEMBLE. Incorrect reassembly may result in the risk of electric shock, fire or exposure to battery chemicals. If it is damaged, take it to a MILWAUKEE® service facility.
- BATTERY CHEMICALS CAUSE SERIOUS BURNS. Never allow contact with skin, eyes, or mouth. If a damaged battery leaks battery chemicals, use rubber or neoprene gloves to dispose of it. If skin is exposed to battery fluids, wash with soap and water and rinse with vinegar. If eyes are exposed to battery chemicals, immediately flush with water for 20 minutes and seek medical attention. Remove and dispose of contaminated clothing.
- DO NOT SHORT CIRCUIT. A battery will short circuit if a metal object makes a connection between the positive and negative contacts on the battery pack. Do not place a battery pack near anything that may cause a short circuit, such as coins, keys or nails in your pocket. A short circuited battery may cause fire and personal injury.
- STORE in a cool, dry place. Do not store battery where temperatures may exceed 50°C (120°F) such as in direct sunlight, a vehicle or metal building during the summer.
- TO REDUCE THE RISK OF INJURY, CLOSE SUPERVISION IS NECESSARY when an appliance is used near children.
- STORE IDLE LIGHT OUT OF REACH OF CHILDREN. Warm lights can become hazardous in the hands of children.
- KNOW YOUR LIGHT. Read this manual carefully to learn your light’s applications and limitations as well as potential hazards associated with this type of light.
- MAINTAIN LABELS AND NAMEPLATES. These carry important information. If unreadable or missing, contact a MILWAUKEE® service facility for a replacement.
READ AND SAVE ALL INSTRUCTIONS FOR FUTURE REFERENCE.
ADDITIONAL BATTERY SAFETY RULES
Warning: To reduce the risk of fire, personal injury,
and product damage due to a short circuit, never immerse your tool, battery
pack or charger in fluid or allow a fluid to flow inside them. Corrosive or
conductive fluids, such as seawater, certain industrial chemicals, and bleach
or bleach-containing products, etc., can cause a short circuit.
SPECIFICATIONS
- Cat. No: L4 HL
- Power rated: 6W
- Ingress Protection: IP53
- USB Input Volts: 5V
- DC USB Input Amps: 0.1 – 2.1A
- Output Volts: 4V DC
- Output Amps: 2.1A
REDLITHIUM™ USB Batteries
- Volts : 4V DC
Operating Temperature
- Battery and Charger: 4°C to 40°C (40°F to 104°F)
- Battery and Tool: -18°C to 65°C (0 °F to 149°F)
SYMBOLOGY
- V Volts
- Direct Current
- A Amps
- Regulatory Compliance mark (RCM). This product meets applicable regulatory requirements.
- Do not stare at light source
- Read Operator’s Manual
- Class III protection
BATTERY
Maintenance and Storage
Do not expose your battery or cordless tools to water or rain, or allow them to get wet. This could damage the tool and battery. Do not use oil or solvents to clean or lubricate your battery. The plastic casing will become brittle and crack, causing a risk of injury. Store batteries at room temperature away from moisture. Do not store in damp locations where corrosion of terminals may occur. As with other battery types, permanent capacity loss can result if the pack is stored for long periods of time at high temperatures over 50°C (120°F). MILWAUKEE® Li-Ion batteries maintai their charge during storage longer than other battery types. After about a year of storage, charge the battery as normal.
Waning: T o reduce the risk of injury or explosion,
never burn or incinerate a battery pack even if it is damaged, dead or
completely discharged. When burned, toxic fumes and materials are created.
Disposing of MILWAUKEE® Li-Ion Battery
MILWAUKEE® Li-Ion batteries are more environmentally friendly than some
other types of power tool batteries. Always dispose of your battery according
to federal, state and local regulations. Contact a recycling agency in your
area for recycling locations. Even discharged batteries contain some energy.
Before disposing, use electrical tape to cover the terminals to prevent the
battery from shorting, which could cause a fire or explosion.
REDLITHIUMTM USB HARD HAT HEADLAMP
WARNING: Use and charge only REDLITHIUMTM USB batteries in
this USB rechargeable light. Other types of batteries may cause personal
injury and damage
Inserting the Battery
- Open the battery door.
- Line up the battery with the compartment and fully insert the battery.
- Close the battery door.
Charging the Battery
- Plug your USB cable into a power source such as an AC wall adaptor, computer or car port.
- Lift the rubber cover to expose the micro USB port.
Insert the micro USB plug into the micro USB port.
The indicator light will display the charging status:
Red Flashing: Charging, 0-25% charged
Orange Flashing: Charging, 25-80% charged
Green Flashing: Charging, 80-99% charged
Green Solid: 99-100% Charged
Red/Green Flashing: Damaged or Faulty Battery
If the light indicator flashes red and green, check that the battery is fully seated into the bay. Remove the battery and reinsert. If the light continues to flash red and green, the battery may be extremely hot or cold, or wet. Allow the battery to cool down, warm up, or dry out and then reinsert. If the problem persists, contact a MILWAUKEE® service facility
Operation
WARNING: To reduce the risk of injury, do not look
directly into the light when the light is on.
Clip the light onto the strap and use the buckle to adjust the strap to the required size. Use the included clips to attach to a hard hat. Rotate the light up or down as needed.
Press the power button (I) to turn the light on and off.
Press the mode button to cycle through Hybrid Spot/Flood, High Flood, Medium Flood, Low Flood and Spot.
The fuel gauge will display the battery life:
- Red Flashing: 0-10% remaining
- Red Solid: 10-25% remaining
- Orange Solid: 25-80% remaining
- Green Solid: 80-100% remaining
WARNING: To reduce the risk of injury, always unplug the
charger and remove the battery from the charger before performing any
maintenance. The charger and battery have no internal serviceable parts. Never
disassemble the battery or charger.
WARNING: The light source of this luminaire is not
replaceable; when the light source reaches its end of life the whole luminaire
shall be replaced.
Maintenance and Storage
Store your charger in a cool, dry place.
As a general practice, it is best to unplug battery chargers and remove
batteries when not in use. No battery damage will occur, however, if the
charger and battery are left plugged in.
WARNING: To reduce the risk of injury and damage, never
immerse your battery or charger in liquid or allow a liquid to flow inside
them
Cleaning
Clean out dust and debris from charger vents and electrical contacts by blowing with compressed air. Use only mild soap and a damp cloth to clean the battery and charger, keeping away from all electrical contacts. Certain cleaning agents and solvents are harmful to plastics and other insulated parts. Some of these include gasoline, turpentine, lacquer thinner, paint thinner, chlorinated cleaning solvents, ammonia and household detergents containing ammonia. Never use flammable or combustible solvents around batteries, charger, or tools.
Warranty
WARRANTY – AUSTRALIA and NEW ZEALAND
Please refer to Australian and New Zealand warranty supplied with tool. This warranty applies only to product sold by authorised dealers in Australia and New Zealand.
SERVICE
SERVICE – AUSTRALIA and NEW ZEALAND
MILWAUKEE® prides itself in producing a premium quality product that is Nothing But Heavy Duty™. Your satisfaction with our products is very important to us! If you encounter any problems with the operation of this tool, please contact your authorised MILWAUKEE® dealer.
For a list of MILWAUKEE® dealers, guarantee or service agents please contact MILWAUKEE
Customer Service or visit our website.
(Australia Toll Free Telephone Number 1300 645 928)
(New Zealand Toll Free Telephone Number 0800 645 928)
or visit
milwaukeetool.com.au/milwaukeetool.co.nz.
Milwaukee Electric Tool Corporation
13135 West Lisbon Road, Brookfield, Wisconsin U.S.A. 53005
Milwaukee Tool (Australia)
21 Kelletts Road, Rowville, VIC 3178
Melbourne, Australia
Milwaukee Tool (New Zealand)
274 Church Street, Penrose,
Auckland, 1061, New Zealand
DESIGNED BY MILWAUKEE ELECTRIC TOOL CORP.
PROFESSIONALLY MADE IN CHINA
PRINTED IN CHINA
Documents / Resources
|
milwaukee REDLITHIUM USB HARD HAT
HEADLAMP
[pdf] Instructions
REDLITHIUM USB HARD HAT HEADLAMP
---|---
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>