Z-WAVE PLUS HE-HT01 Heating Thermostat User Guide
- June 7, 2024
- Z-Wave Plus
Table of Contents
Z-Wave Protocol Implementation Conformance Statement
Heating Thermostat
General Information
| Product Identifier: | HE-HT01 |
|---|---|
| Brand Name: | HELTON |
| Product Version: | HW: 12 FW: 2.01 |
| Z-Wave Certification #: | ZC12-19120023 |
Product Features
| Neutral Wire Required | Yes |
|---|---|
| Switch Load Capacity Current | 16A |
| Switch Load Capacity Watts | 4000 |
| Switch Type | Dry Contact |
| Thermostat HVAC Systems Supported | Heat Only |
| Thermostat Modes | Auto Changeover |
Away
Dry Air
Energy Save Heat
Heat
Thermostat Power Source| Mains powered (120V/240V)
Power Stealing (hard-wired 24V)
Firmware Updatable| Updatable by Consumer by RF
Z-Wave Product Information
| Supports Z-Wave Beaming Technology? | Yes |
|---|---|
| Supports Z-Wave Network Security? | Yes |
| Supports Z-Wave AES-128 Security S0? | Yes |
| Supports Security S2? | Yes: S2 Authenticated, S2 Unauthenticated |
| SmartStart Compatible? | Yes |
Z-Wave Product Information
Z-Wave Frequency:| Chile, Australia / New Zealand, Brazil, China, Hong Kong,
India, Israel, Japan, Malaysia, Russia, Singapore, South Africa, South Korea,
UAE, U.S. / Canada / Mexico, CEPT
(Europe)
---|---
Z-Wave Product ID:| 0x0001
Z-Wave Product Type:| 0x0004
Z-Wave Hardware Platform:| ZGM130
Z-Wave Development Kit Version:| 7.11.1
Z-Wave Library Type:| Enhanced 232 Slave
Z-Wave Device Type / Role Type:| Thermostat – HVAC / Always On Slave
Association Group Information
Group # / Max Description
Nodes
1 / 1| This is the Lifeline Group 1 which sends status (lifeline) reports to
the primary controller.
---|---
2 / 1| Group 2 – “Basic Set On/Off”: is assigned to the HE-HT01 operating
state. It sends a Basic Set command with
value 0 (Off) when it goes to IDLE state and sends 255 (ON) when it goes into
HEATING state.
Supported Command Classes (23):
| Application Status | Association Group Information V3 |
|---|---|
| Association V2 | Basic V2 |
| Clock | Configuration V4 |
| Device Reset Locally | Firmware Update Meta-Data V5 |
| Indicator V3 | Manufacturer Specific V2 |
| Meter V4 | Multi-Channel Association V3 |
| Powerlevel | Security S0 |
| Security S2 | Sensor Multilevel V11 |
| Supervision | Thermostat Mode V3 |
| Thermostat Operating State | Thermostat Setpoint V3 |
| Transport Service V2 | Version V3 |
Z-Wave Plus Info V2
Copyright © 2012-2021 Z-Wave Alliance.
All Rights Reserved. All Logos property of respective rights’ holders, no
claim intended.
Generated @ August 24, 2021
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>