ULINE Flat File Cabinet Instructions
- June 7, 2024
- ULINE
Table of Contents
H-8796, H-8797
FLAT FILE CABINET
1-800 -295-5510
uline.com
TOOLS NEEDED
PARTS
ASSEMBLY
HANDLES AND LABEL HOLDERS
- Place the handle on the front of the drawer and insert two M4 x 6 mm handle screws with two M4 washers through the opposite side. Tighten using a Phillips screwdriver. Repeat for all drawers. (See Figure 1)
- Attach label holders by pushing tabs through slots in front of the drawer and bending tabs on the back of the drawer toward the center to secure.
STACKING
-
Remove bottom drawer (A) of the top unit and top drawer (B) of the bottom unit. (See Figure 2)
NOTE: To remove drawers, pull drawers straight out and lift them up.
-
Remove knockout caps on top of the bottom unit.
NOTE: Knockout caps can be removed using a flathead screwdriver and rubber mallet. Stand the flathead screwdriver on the knockout caps and tap the top of the screwdriver handle with the rubber mallet to knock the caps off. -
Stack units and align holes at the front ledge of units.
Insert M6 x 55 mm bolts into the top and bottom unit. Attach M6 nuts and tighten to secure.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>