ULINE Stainless Steel Work Table Instruction Manual
- June 7, 2024
- ULINE
Table of Contents
ULINE Stainless Steel Work Table
TOOL NEEDED
PARTS
ASSEMBLY
-
With the undershelf on its side, push the legs through the collars to the desired height. To ensure exact height, mark desired height on each leg with magic marker or grease pencil.
-
Secure legs to undershelf with set screws using 5/32″ Allen wrench.
-
Stand table upright and place tabletop onto legs, inserting legs into tabletop gussets. With a 5/32″ Allen wrench, tighten set screw on each gusset.
-
Level table with the adjustable feet. Adjustable feet allow approximately 1″ of adjustment.
OPTIONAL CASTERS
-
Flip the table back over onto a smooth, non-marring surface. Remove adjustable feet from tube legs using a flat head screwdriver.
-
Hold caster base and rotate nylon bushing clockwise. This will cause the rubber piece to expand.
-
Expand the rubber enough so that it will fit snugly into the tube leg.
-
With caster fully inserted into the leg, turn clockwise until caster is secured to tube leg.
