ULINE H-4588, H-4589, H-4591 Portable Sign Base Instruction Manual
- June 7, 2024
- ULINE
Table of Contents
H-4588, H-4589
H-4591
1-800 -295-5510
PORTABLE SIGN BASE
uline.com
TOOLS NEEDED
PARTS
ASSEMBLY
-
Attach one bolt and one nut to each bracket assembly. Fully tighten. (See Figure 1)
-
Position the two bracket assemblies onto the PVC post in the desired location to mount the sign. Fully tighten the brackets using a 7/16″ wrench and screwdriver. Slip one
washer onto each of the two protruding bolts of the bracket assembly. (See Figure 2)
-
Mount the sign into place on the two protruding bolts of the bracket assemblies.
-
Slip one washer onto each of the two protruding bolts over the sign.
-
Using the two remaining nuts, secure the sign to each of the bracket assemblies.
-
Place the rubber base onto a flat surface. Wet the bottom of the post and base hole with water to lubricate.
-
Holding the post at a slight angle, press-fit the post into the base. (See Figure 3)
-
Carefully pound the top of the PVC post with a hammer until the post is snug inside the base. Make sure the post is press-fit to the bottom of the base.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>