V-TAC VT-7009, VT-7009CH MIRROR LIGHTS Installation Guide
- June 7, 2024
- V TAC
Table of Contents
WEEE Number: 80133970
INSTALLATION INSTRUCTION
MIRROR LIGHTS
VT-7009, VT-7009CH
TECHNICAL DATA:
SKU No.
| 3983(3000K), 3901(4000K)|
3984(3000K), 3900(4000K)
---|---|---
Power:| 8W| 8W
Input Voltage:
| AC:220-240V,50Hz|
AC:220-240V,50Hz
Lumens:
| 600lm| 600lm
Beam Angle:
| 120°|
120°
CRI:
| >80| >80
Protection Rating:
| IP20|
IP20
Driver Connections:
1.) For drivers which have to be connected to the lamp make sure the
connections are made right. You can also view the driver specification labeled
on the product.
2.) If the driver is built-in please ignore this section.
3.) This section will not be applicable for items that do not require a
driver.
Wire Colours
N – Black or Blue wire
Ground – Yellow Or Yellow-Green
L – Brown/Red Wire|
---|---
INSTALLATION DIAGRAM:
INTRODUCTION & WARRANTY
Thank you for selecting and buying the V-TAC product. V-TAC will serve you the
best. Please read these instructions carefully before starting the installing
and keep this manual handy for future reference. If you have any other
queries, please contact our dealer or local vendor from whom you have
purchased the product. They are trained and ready to serve you at your best.
The warranty is valid for 3 years from the date of purchase. The warranty does
not apply to damage caused by incorrect installation or abnormal wear and
tear. The company gives no warranty against damage to any surface due to
incorrect removal and installation of the
product. The products are suitable for 10-12 Hours Daily operation. Usage of
product for 24 Hours a day would void the warranty. This product is warranted
for manufacturing defects only.
ATTENTION!
- Switch off the power before installing or making any adjustment to then lamp.
- Before connecting the power supply, please refer to manual inside or on the box.
- Always consult certified electrician for installation of the lamp/fitting.
- If you need any assistance with installation please contact us at the email address specified at the bottom of the page.
INSTALLATION INSTRUCTION
- Switch off the power.
- Cut appropriate size hole on the wall. Put the rubber plug into the hole. Fix the bracket on the ceiling with screw.
- Connect the AC.
- Install the lamp body into the bracket and tighten the screw safely and solidly.
In case of any query/issue with the product, please reach out to us at:
support@v-tac.eu
For More products range, inquiry please contact our distributor or nearest
dealers. V-TAC EUROPE LTD
Bulgaria, Plovdiv 4000, bul.L.Karavelow 9B
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>