SEDONA LYNX Insulated Jacket Installation Guide
- June 7, 2024
- SEDONA
Table of Contents
SEDONA LYNX Insulated Jacket Installation Guide
IMPORTANT: Before you build the frame, you must take into consideration the total weight of the liner, grill and any fi nishing materials
LINER INSTALLATION
Posititon the liner into the frame. No part of the combustible enclosure can protrude above the top surface or in front of the face surface of the liner. Shim the liner if necessary
GRILL INSTALLATION
Use the proper equipment to support the grill. Place the grill into the liner and engage it over the liner lip across the backand sides. The liner is designed to support the grill without additional fasteners.
FINISHING
If desired any gap remaining between the liner and the combustible enclosure
may be filled with a noncombustible sealant or caulk.
Refer to the table below for the proper framing dimensions for the insulation jacket. Determine the entry point for both the gas inlet and electrical connections. Make the 4” square holes for gas and electrical connections (rear or bottom access) based on your requirements. Note that the electrical connections are located on the left side and the gas connections are located on the right side.
A Carpenter’s “spirit level” should be used to assure that the framing is
level, both front to back and side to side.
Note: Never under any circumstance should you install the transformer or run a
quick disconnect hose in-between the grill and the inside of the insulating
jacket.
| Model | A | B | C | D | E | F |
|---|---|---|---|---|---|---|
| LIJ400 | 30 | 2 ¼ | 23 ¼ | 3 ½ | 2 | 11 5/8 |
| LIJ500 | 36 | 2 ¼ | 23 ¼ | 3 ½ | 2 | 11 5/8 |
| LIJ600 | 42 | 2 ¼ | 23 ¼ | 3 ½ | 2 | 11 5/8 |
| LIJ700 | 48 | 2 ¼ | 23 ¼ | 3 ½ | 2 | 11 5/8 |
1” Screws can be provided to help straighten out the sides of the LIJ if necessary. Contact customer service for details.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>