SEDONA LIJ400 Insulated Jacket 24 Inch Grill Instruction Manual

June 3, 2024
SEDONA

SEDONA BY LYNX™ INSULATED JACKET
INSTALLATION INSTRUCTIONS

LIJ400 Insulated Jacket 24 Inch Grill

IMPORTANT: Before you build the frame, you must take into consideration the total weight of the liner, grill, and any finishing materials.

Refer to the table below for the proper framing dimensions for the insulation jacket. Determine the entry point for both the gas inlet and electrical connections. Make the 4” square holes for gas and electrical connections (rear or bottom access) based on your requirements. Note that the electrical connections are located on the left side and the gas connections are located on the right side.
A Carpenter’s “spirit level” should be used to assure that the framing is level, both front to back and side to side.
Note: Never under any circumstance should you install the transformer or run a quick disconnect hose in-between the grill and the inside of the insulating jacket.

Model A B C D E F
LIJ400 30 2 ¼ 23 ¼ 3 ½ 2 11 5/8
LIJ500 36 2 ¼ 23 ¼ 3 ½ 2 11 5/8
LIJ600 42 2 ¼ 23 ¼ 3 ½ 2 11 5/8
LIJ700 48 2 ¼ 23 ¼ 3 ½ 2 11 5/8

1” Screws can be provided to help straighten out the sides of the LIJ if necessary. Contact customer service for details.

LINER INSTALLATION

Position the liner into the frame. No part of the combustible enclosure can protrude above the top surface or in front of the face surface of the liner. Shim the liner if necessary.

GRILL INSTALLATION

Use the proper equipment to support the grill. Place the grill into the liner and engage it over the liner lip across the back and sides. The liner is designed to support the grill without additional fasteners.

FINISHING

If desired any gap remaining between the liner and the combustible enclosure may be filled with a non-combustible sealant or caulk.

P/N 35031 Rev A. 2017

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals