Ruko Wire-free Video Doorbell & Chime SE User Guide
- June 9, 2024
- Ruko
Table of Contents
Ruko Wire-free Video Doorbell & Chime SE User Guide
For the best experience Charge your doorbell before setup
To charge doorbell: Plug one end of the charging cable into the micro USB
port on the back of your doorbell. Connect the other end to a standard USB
power adaptor (like your phone charger).
What’s included
- A Roku Wire-free Video Doorbell SE
- B Roku Enhanced Chime SE
- C USB charging cable
- D Screw back plate
- E Back plate
- F Corner kit
- G Wire caps (x3)
- H Short screws (x3)
- I Extension wires (x2)
- J T8 screwdriver
- K Long screws (x3)
- L Plastic anchors (x3)
- M Adhesive strip
- N Jump wire
What you’ll need
- Your smartphone
- Light sensor
- Lens
- Motion sensor
- Microphone
- Doorbell button
- Speaker
- Micro USB charging port
- Power button
- Screw terminals
- Status light
- Setup button
- Speaker
Let’s get started
STEP 1: Download the Roku Smart Home app Scan the QR code below to download the Roku Smart Home app on your smartphone. Sign in with your Roku account or create one.
STEP 2: Install your doorbell & chime
In the Roku Smart Home app, tap the “+” button, then “Add Device” to find
“Wire-free Video Doorbell.” Follow the instructions to finish setup.
What’s that light mean?
More features are waiting
Unlock the full potential of your doorbell with a Roku Smart Home
Subscription.
Learn more at go.roku.com/rokusmarthome
FCC WARNING
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation. Note: This
equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Caution: Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
FCC RADIATION EXPOSURE STATEMENT
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with
minimum distance 20cm between the radiator and your body.
WARNING
Do not use the battery near a heat source. Do not use the battery near fire or
an oven, or in an ambient temperature exceeding 80°C. Over-heating may cause
an internal short-circuit, heat generation, smoking, deformation or burning.
CONTAINS A LITHIUM ION BATTERY
Always dispose of batteries following local recycling guidelines. Do not
dispose of batteries in household waste or open fire. For more information
about recycling and the battery included, see:
https://support.roku.com/article/208755678
Need help?
Visit go.roku.com/doorbells
© 2022 Roku, Inc. All rights reserved. Roku, the Roku logo, Roku Smart Home,
and the Roku Smart Home logo are the trademarks or registered trademarks of
Roku, Inc.
4100000866_02
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>