ULINE H-7162 24″ LED Light Installation Guide
- June 7, 2024
- ULINE
Table of Contents
ULINE H-7162 24″ LED Light Installation Guide
TOOL NEEDED
Phillips Screwdriver
SAFETY
CAUTION! Read all instructions and warnings before operating.
WARNING! To avoid serious injury or death from electrical shock or fire adhere to the following safety warnings.
-
Do not plug in LED light when hands are wet or damp, or when standing on a wet or damp surface or in
-
Always use in accordance with electrical and safety codes and ordinances, including the most recent National Electric Code (NEC) and with the
Occupational Safety and Health Act (OSHA) Volume 1 on General Industry Standards and interpretations. -
Always ensure the power source conforms to the requirements on the
-
Always disconnect the power before servicing or inspecting the LED light for any
-
For use only on 110V-125V (single phase) and is equipped with an approved polarized
IMPORTANT! The LED light has a polarized attachment plug (one blade is
wider than the other). The plug fits in a polarized outlet only one way. If the plug does not fit fully in
the outlet, rotate the plug. If it still does not fit, contact a qualified electrician.
- Do not use an extension cord unless the plug can be fully
- The LED light is not waterproof and is not intended for use in showers, saunas or in potentially wet The entry of moisture into the light may cause damage and void warranty.
- For indoor use Do not use in flammable or explosive atmospheres. Potential ignition may occur.
- Keep away from heating vents, radiators, or other sources of
- Keep out of reach of children.
MOUNTING
-
The LED light comes with two magnets (A) for attaching to most metal surfaces.
-
Adjust the magnet positions for proper mounting distance:
a Use a Phillips screwdriver to loosen the screw (B).
b Slide the magnet (A) to desired position, then tighten the screw to lock in position.
NOTE: Do not remove the screw from the magnet. -
Plug into any 110-125V standard wall outlet.
-
Press the switch (C) to turn on the Press again to turn off the light.
ELECTRICAL RATINGS
| CORD LENGTH | CORD TYPE/GAUGE | LUMENS | MAXIMUM RATING |
|---|---|---|---|
| 6 ft. | SJT 18/3 | 1,635 | 20 Watts, 120 V AC, 60 Hz |
MAINTENANCE
-
Do not attempt to replace LED If properly cared for the LED light will provide up to 50,000 hours of use.
WARNING! Unplug unit before attempting any maintenance. -
Remove dirt and grime as soon as it
-
Use a soft, damp cloth and a mild soap, if needed.
-
Do not to get the electrical plug
-
Never submerge any part of the LED light in any solution to clean
-
Do not use solvents such as gasoline or turpentine to clean
Read More About This Manual & Download PDF:
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>