ULINE Drop Over Cable Protector Instructions

ULINE Drop Over Cable Protector

INSTRUCTIONS

COMPONENTS

NOTE: Drop over protectors do not prevent abrasion to cable from below.

ASSEMBLY

Interlock with T-connectors to extend protection length. (See Figure 1)

• Inspect areas for safety hazards.
• Assemble sections by aligning female connectors over male connectors and press with foot to secure.
• Install cable as required. Place the protector over the top of exposed cable/hose.
• Test installation for intended use.
• Periodically inspect installation.

CHANNEL CAPACITY

C H A NN E L CAPACITY – MAX. DIAMETER INCHES

H-4616| 1.25″ width x 1.25″ height
H-4617| 2.25″ width x 2.25″ height

LOAD CAPACITY

The Drop Over Cable Protector has different load supporting capabilities depending on type of vehicle and temperature. Suitability must be verified by testing under actual conditions.
Load-supporting capacity varies by type of loading conditions and environmental conditions. The load capacity decreases in warm environments. Test before use and inspect periodically.

MODEL NO.| LOAD CAPACITY PER TIRE MAX LOAD 70°F (21°C)| LOAD CAPACITY PER AXLE MAX LOAD 70°F (21°C)
---|---|---
H-4616| 11,700 lbs.| 23,400 lbs.
H-4617| 8,500 lbs.| 17,000 lbs.

OPERATING TEMPERATURE
-40° to 120°F (-40° to 48°C)
CHEMICAL RESISTANCE
Tested for compatibility with common motor oils, gasoline and diesel fuel. Limited resistance to brake fluids and other chemicals.
MATERIAL
UV-stabilized polyurethane elastomer.

CAUTION! Misuse can cause electrical shock and injury.

• DO NOT use as work surface. NO CUTTING, NO DRILLING, NO HAMMERING.
• Use with momentary loads only. DO NOT place ladders, scaffolds or any type of structure on the protector.
• Avoid concentrated loads.
• Use only on a stable surface. Inclined surfaces, slippery surfaces and broken ground can cause injury.
• This protector can be a trip hazard to pedestrian traffic if they are unaware of its presence.
• Keep the Drop Over Cable Protector clean and bright.
• Keep various services, communications, fluids and power separated. Limit a protector to one service type.
• Polyurethane is attacked by some chemicals. Always test a small amount for chemical compatibility before using and follow maintenance procedure.
• Vehicular traffic must pass over the protector slowly and with caution.

MAINTENANCE

• Store in a clean dry area.
• Inspect protector for damage and replace it if damaged.
• Remove any foreign materials, solids and liquids.
• Keep clean by using a detergent and water solution.

1-800-295-5510
uline.com

Documents / Resources

| ULINE Drop Over Cable Protector [pdf] Instructions
ULINE, H-4616, H-4617, Drop Over Cable Protector
---|---

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>