ULINE H-5501 Heavy Duty 5 Channel Cable Protector Instructions
- June 7, 2024
- ULINE
Table of Contents
H-5501 HEAVY DUTY 5 CHANNEL CABLE
PROTECTOR
1-800-295-5510
uline.com
INSTRUCTIONS
COMPONENTS
ASSEMBLY
Interlock with dog-bone connectors to extend protection length. (See Figure
1)
- Inspect areas for safety hazards.
- Assemble sections by aligning female connectors over male connectors and press with the foot to secure.
- Open the cover and install cables down into channels.
- Close cover flush with the base.
- Test installation for the intended use.
- Periodically inspect the installation.
CHANNEL CAPACITY
CHANNEL CAPACITY – MAXIMUM DIAMETER
4 Outer Channels| 1.375′ width x ln height
Center Channel| 1.65′ width x ln height
LOAD CAPACITY
The heavy-duty 5 channel cable protector has different load supporting
capabilities depending on the type of vehicle and temperature. The load
capacity decreases in warm environments. Test before use and inspect
periodically. Suitability must be verified by testing under actual conditions.
MODEL
NO.| LOAD CAPACITY PER TIRE
MAX LOAD 70°F (21°C)| LOAD CAPACITY PER AXLE
MAX LOAD 70°F (21°C)
---|---|---
H-5501| 16,300 lbs.| 32,600 lbs.
OPERATING TEMPERATURE
-40° to 120°F (-40° to 48°C)
CHEMICAL RESISTANCE
Tested for compatibility with common motor oils, gasoline, and diesel fuel.
Limited resistance to brake fluids and other chemicals.
MATERIAL
UV-stabilized polyurethane elastomer.
INSTRUCTIONS CONTINUED
CAUTION! Misuse can cause electrical shock and injury.
- DO NOT use as a work surface. NO CUTTING, NO DRILLING, NO HAMMERING.
- Use with momentary loads only. DO NOT place ladders, scaffolds, or any type of structure on the protector.
- Avoid concentrated loads.
- Use only on a stable surface. Inclined surfaces, slippery surfaces, and broken ground can cause injury.
- This protector can be a trip hazard to pedestrian traffic if they are unaware of its presence.
- Keep the heavy-duty 5 channel cable protector clean and bright.
- Keep various services, communications, fluids, and power separated. Limit a channel to one service type.
- Polyurethane is attacked by some chemicals. Always test a small amount for chemical compatibility before using and follow maintenance procedures.
- Vehicular traffic must pass over the protector slowly and with caution.
MAINTENANCE
- Store in a clean, dry area.
- Inspect the protector for damage and replace it if damaged.
- Remove any foreign materials, solids, and liquids.
- Keep clean by using a detergent and water solution.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>