ULINE H-4810, H-4811 Locker Locks Installation Guide
- June 7, 2024
- ULINE
Table of Contents
H-4810, H-4811
LOCKER LOCKS
**TOOLS NEEDED
**
INSTALLATION
-
Above the handle on the front of the locker, locate the three circular indents. The middle circle will be larger than the top and bottom circles. (See Figure 1)
-
Open door. From inside, remove the two nuts and washers holding on the steel plate using a 7mm wrench. Remove the two bolts from the front. (See Figure 2)
NOTE: For Six Tier Uline Industrial Lockers, steel plate is attached to door with rivets. To remove, use a power drill and drill bit to drill out the two rivets holding on the steel plate.
To install locker lock, set dial at 0 and
remove rear mounting plate of locker lock. Put rear mounting plate up against
the inside of the locker door and the front of the lock-up against the outside
of the door. Push the two pieces together so that mounting bolts stick out
through the mounting plate. Secure with nuts and tighten using an 8mm wrench.
(See Figure 3)
0521 IH-4810
Documents / Resources
|
ULINE H-4810, H-4811 Locker
Locks
[pdf] Installation Guide
H-4810, H-4811, Locker Locks
---|---
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>