WALI TVDVD-03 Installation Guide
- June 7, 2024
- WALI
Table of Contents
INSTALLATION MANUAL
WL-TVDVD-03
upport@walielectric.com
UNPACKING INSTRUCTIONS
- Carefully open the carton, remove contents, and layout on cardboard or another protective surface to avoid damage.
- Check package contents against the Supplied Parts List on the next page to assure that all components were received undamaged. Do not use damaged or defective parts.
- Carefully read all instructions before attempting installation.
IMPORTANT SAFETY INFORMATION
Install and operate this device with care. Please read this instruction before
beginning the installation, and carefully follow all instructions contained
herein. Use proper safety equipment during installation.
Please call a qualified installation contractor for help if you:
- If you don’t understand these directions or have any doubts about the safety of the installation.
- If you are uncertain about the nature of your wall, consult a qualified installation contractor.
Do not use this product for any purpose or in any configuration not explicitly
specified in this instruction.
We hereby disclaim any and all liability for injury or damage arising from
incorrect assembly, incorrect mounting, or incorrect use of this product.
Supplied Parts List
|
---|---
|
|
**Step 1**
Connecting the Support Column to Tempered Glass
Step 2
Mounting column, connector, and head part
**Step 3**
Mounting TV plate to the headstock
**Step 4**
Mounting the Monitor Brackets to a TV
First of all, make sure your TV mounting holes are compatible with the size
and diameter of the provided Bolt (l to r). Once you have determined the
correct diameter, please see the diagram below. Install the Bolt into the TV
using the correct Washer(s,t,u), and using the spacer(v,w) if necessary.
Please make sure the Monitor Brackets are vertically centered and level with
each other.
Adjust the monitor brackets to different heights according to your viewing and
setup preference.
**Step 5**
Attaching TV To TV Plate and Managing the Wires
Step 6
Attaching the Security Steel Wire to the TV
If your TV is positioned close to the wall as shown in Diagram 5a, then a
steel wire can be attached for added security.
Attach two ends of the steel wire to the top two holes on the back of TV,
shown in Diagram 5b.
Attach the other end of the steel wire to the wall
according to your wall type, shown in Diagram 5c, 5d and 5e.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>