MAYTAG Freestanding Electric Range User Guide
- June 7, 2024
- Maytag
Table of Contents
Freestanding Electric Range
Quick Start Guide
OPERATING INSTRUCTIONS
WARNING: To reduce the risk of fire, electric shock, or injury to persons, read the IMPORTANT SAFETY INSTRUCTIONS, located in your appliance’s Owner’s Manual, before operating this appliance.
Using Your Oven
Step 1. Select oven function
Step 2. Set the temperature
Step 3. Press Start
Step 4. Place food inside the oven once the set temperature is reached.
Close the oven door.
Step 5. (Optional) Enter time to cook
Step 6. The Cancel button can be used to cancel the function during or
after cook time.
NOTE: For more detailed instructions on specific functions, see the
online Control Guide.
Using Your Range
WARNING
Fire Hazard
Turn off all controls when done cooking.
Failure to do so could result in death or fire.
The control knobs can be set to anywhere between Hi and Lo or Melt. Push in
and turn to seting.
REMEMBER: When the range is in use or (on some models) during the Self-
Cleaning cycle, the entire cooktop area may become hot.
POSITIONING RACKS AND BAKEWARE
IMPORTANT: To avoid permanent damage to the porcelain finish, do not
place food or bakeware directly on the oven door or bottom.
Racks
- Position racks before turning on the oven.
- Do not move racks with bakeware on them.
- Make sure racks are level.
To move a rack, pull it out to the stop position, raise the front edge, and then lift out. Use the following illustration as a guide.
BAKING COOKIES AND LAYER CAKES ON 2 RACKS
Baking Layer Cakes
For best results when baking cakes on two racks, use the Bake function, a flat
rack in rack position 4, and a flat rack in rack position 2. Place the cakes
on the racks as shown. Keep at least 3″ (7.6 cm) of space between the front of
the racks and the front cakes.
Baking Cookies
For best results when baking cookies on two racks, use the Convect Bake
function (on some models) and place flat racks in positions 2 and 5.
ALUMINUM FOIL
IMPORTANT: To avoid permanent damage to the oven bottom finish, do not
line the oven bottom with any type of foil or liner.
For best cooking results, do not cover the entire oven rack with foil because
air must be able to move freely.
Care must be taken to prevent aluminum foil and meat probes from contacting
heating elements.
OVEN VENT
The oven vent releases hot air and moisture from the oven, and should not be
blocked or covered. Blocking or covering the oven vent will cause poor air
circulation, affecting cooking and cleaning results. Do not set plastics,
paper, or other items that could melt or burn near the oven vent.
OVEN LIGHT
The oven light is a 40 W halogen bulb. Before replacing, make sure the oven
and cooktop are cool and the control knobs are in the Off position.
To Replace:
- Disconnect power.
- Turn the glass bulb cover in the back of the oven counterclockwise to remove.
- Remove the bulb from the socket.
- Replace bulb, using tissue or wearing cotton gloves to handle bulb. To avoid damage to or decreasing the life of the new bulb, do not touch the bulb with bare fingers.
- Replace bulb cover by turning clockwise.
- Reconnect power.
IMPORTANT: Do not use lamps rated higher than 40 W.
SABBATH MODE:
The Sabbath Mode sets the oven to remain on in a bake setting until disabled.
For guidance on usage and a complete list of models with Sabbath Mode, visit
www.star-k.org or contact us as per the information
given below.
Online Ordering Information
For detailed installation instruction and maintenance information, winter
storage, and transportation tips, please see the Owner’s Manual included with
your machine.
For information on any of the following items, a full-cycle guide, warranty,
detailed product dimensions, or for complete instructions for use and
installation, please visit https://www.whirlpool.com/owners, or in Canada
https://www.whirlpool.ca/owners. This may save you the cost of a service
call.
However, if you need to contact us, use the information listed below for the appropriate region.
United States:
1–800–253–1301
Whirlpool Brand Home Appliances
Customer Experience Center
553 Benson Road
Benton Harbor, MI 49022–2692| Canada:
1–800–807–6777
Whirlpool Brand Home Appliances
Customer Experience Centre
200–6750 Century Ave.
Mississauga, Ontario L5N 0B7
---|---
IMPORTANT: Retain this guide for future use.
®/™ ©2021
Maytag. All rights reserved. Used under license in Canada.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>