DIGITUS DA-90422 Ergonomic Stool Installation Guide
- June 7, 2024
- DIGITUS
Table of Contents
DIGITUS DA-90422 Ergonomic Stool
Assembly Instructions
Step 1 : Remove and discard the red plastic cap covering the tip of the
gas spring.
Step 2: Insert the gas spring (C) into the base (D). Once aligned correctly, press down firmly.
Step 3: Connect the Plastic Collar (B) to the Seat (A) by resting
the Seat on the cushion and firmly pressing the Plastic Tube against the seat
Step 4: Gently slide the seat onto the gas spring. Once aligned properly,
press down firmly on the seat.
Warning: The red plastic cap must be removed before use.
Failure to remove it will make the stool malfunction.
Operating Instructions
Step 1: To raise the seat, gently press any 1 of the 3 undersea buttons.
Step 2: To lower the seat: Gently press any 1 of the 3 underseat buttons
and simultaneously press down on the seat (or sit on the seat).
Tip:
If the seat does not raise easily:
- Be sure the red plastic cap on top of the gas spring has been removed.
- If Wobble Stool is assembled correctly, add additional pressure to the seat by pushing down or sitting on it to secure the connection for proper use.
Sitting Instructions
Step 1: The stool’s base is unstable. The stool rocks, tilts, tips and the seat swivels 360°. It is not a stationary chair. Extreme care must be used when sitting on the stool.
Step 2: Only sit on the stool if both of your feet are planted firmly on
the ground supporting your entire bodyweight.
Warning:
Do not lean back. To reduce fall risk, do not tip wobble stool past vertical.
Not for use by children. Do not use with only 1 foot or no feet on the ground.
Hereby Assmann Electronic GmbH declares that the Declaration of Conformity is part of the shipping content. If the Declaration of Conformity is missing, you can request it by post under the below mentioned manufacturer address.
www.assmann.com
Assmann Electronic GmbH
Auf dem Schüffel 3
58513 Lüdenscheid
Germany
