C O B O 04610311 Radio components certification User Manual
- June 5, 2024
- C O B O
Table of Contents
C O B O 04610311 Radio components certification User Manual
Radio equipment installed in the vehicle
| Frequency band|
Max Transmission Power
---|---|---
04610311, 04610312
| 134,7 kHz| 38.6 dBµV/m @10m
Radio equipment installed in the vehicle
|
Manufacturers’ addresses
|
04610311, 04610312| C.O.B.O. Spa Via Tito Speri, 10 – 25024 – Leno (BS) –
Italy|
FCC/ISED certifications
The manufacturers of these radio equipment declare that devices comply with the FCC and ISED regulations.
| FCC ID| IC ID
---|---|---
04610311, 04610312| 2AVOV-04610311| 25864-04610311
To comply with FCC and ISED RF exposure compliance requirements, a separation distance of at least 20 cm must be maintained between the antenna of these devices and all nearby persons.
FCC Certification
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
FCC §15.105 Information to the user statements
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
FCC §15.21 Information to user Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
Regulatory & Warnings section of Ducati vehicle manual
ISED Certification
Responsible party’s contact located in the Canada:
Name: Ducati Canada
Address: 777 Bayly Ave. Ajax ON Canada L1S7G7
Contact: Steven Hicks
Tel: cell. +1 705 878 2231 – office +1 705 786 7768
Fax: +1 705 786 7768
Email: steve.hicks@ducati.com
Company n. 23452
This device contains licence-exempt transmitter/receiver that comply with Innovation, Science and Economic Development Canada’s licence exempt RSS(s). Operation is subject to the following two conditions: (1) this device may not cause interference; (2) this device must accept any interference, including interference that may cause undesired operation of the device.
3(B)/NMB-3(B).
CAN ICES-3(B) / NMB-3(B)
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>